User's manual BLUE Edition
2.2Installation of the navigation system
2.2.1Inserting the memory card into the device
Insert the memory Before using MobileNavigator you must insert the memory card card into the device… containing the cartographic data into the device.
1.Unpack the memory card carefully. Pay attention not to touch contacts and not to make them dirty.
2.Hold the memory card 
as shown below (label up, cut corner bottom right). Insert the memory card into the respective slot 
at the left of the device. It should snap in.
Notice: The memory card must stay inserted in the device while you are using the navigation system. If you remove the card while using the system, it executes a soft reset and prompts you to insert the memory card.
2.2.2Installing the navigation software
Install the navigation 1. Take the stylus and push the main switch on the pack of the
software... | device to the ON position. |
|
|
|
|
The brand logo is being displayed for a short time. The installation procedure starts automatically. After a few seconds, the system prompts you to enter the activation
Installation and | - 11 - |