Oricom CARE80 user manual Installation, Connecting the telephone, Wall Mounting

Page 6

Installation

Installation

Connecting the telephone

1.Plug one end of the telephone cable supplied into the TEL. LINE jack at the back of the telephone base.

2.Plug the other end of the telephone cable into the wall outlet.

3.Plug one end of the curly cord into the socket on the handset.

4.Plug the other end of the curly cord into the left side of the telephone.

Wall Mounting

Method A. To fit to an existing telephone wall plate with modular connector simply,

1. Press and lift out the handset holder

4

on base. Rotate it 180°, and snap it

 

into place (see Fig A) so it will hold the

 

handset in place when the phone is

 

mounted on the wall.

 

2.Insert the mounting bracket’s two tabs into the matching slots on the phone’s base. (see Fig B)

3.Then press down and slide the bracket Upward until the tabs snap into place.

4

4

44

Fig A

3

3

 

 

 

 

4.Plug the short telephone line cord (supplied) into the base of the phone and plug the other end into the telephone wall plate socket.

2

1

Fig B

5.Position the mounting holes on the base of the phone over the two protruding screws on the wall plate. Gently push the phone flush against the wall plate then slide the phone downwards locking it into place.

4

Care80 user manual.indd

4

2009-11-5 17:38:00

Image 6
Contents CARE80 2009-11-5 Table of contents General Information Carefully as it contains detailed information onNeed to be aware REN RN for New Zealand Handset in place when the phone is InstallationConnecting the telephone Wall MountingInstallation Location of Controls Operation To Turn on Telstra call waiting Australia Ringer Volume ControlRecall and call waiting Take two different calls at the same timeVolume Control Receiver volume controlHearing Aid Compatibility Memory Dialing using One-touch MemoriesDialing using Two-touch Memories Storing One-touch MemoriesWarranty Information Australia Consumer Support and TroubleshootingCleaning and care WarrantyExclusion and limitation of liability 2009-11-5 Australia