Panasonic KX-TG1805NZ Changing the base unit PIN Personal Identification Number

Page 25

Base Unit Settings

Other options

Changing the base unit PIN (Personal Identification Number)

For security, the base unit PIN must be entered when changing certain settings. The default PIN is 0000.

Important:

LIf you change the PIN, please make note of your new PIN. The unit will not reveal the PIN to you. If you forget your PIN, consult your nearest Panasonic service centre.

1Press {j/OK}.

2Select Base Unit Setup, then press {>}.

3Enter 0000(default base unit PIN). LIf you changed the PIN, enter it.

4Select Other Options, then press {>}.

5Select Base Unit PIN, then press {>}.

6Enter the new 4-digit base unit PIN, then press {j/OK}.

7Press {ih}.

Resetting the base unit to its default settings

1Press {j/OK}.

2Select Base Unit Setup, then press {>}.

3Enter 0000(default base unit PIN). LIf you changed the PIN, enter it (page

25).

4Select Other Options, then press {>}.

5Select Reset Base, then press {>}.

6Select Yes, then press {>}.

7Press {ih}.

Note:

LThe following items will be deleted or reset to their default settings:

Settings listed on page 21

Caller list

LThe following items will be retained:

Date and time

Repeater mode

25

Image 25
Contents Model No. KX-TG1805NZ Introduction Making/Answering Calls Included accessories Accessory informationAdditional/replacement accessories Important information Battery cautionGeneral EnvironmentControls Controls and displaysHandset Charge contact Phonebook Talk Navigator key Base unit Charge contactDisplays ConnectionsDisplay icons Display Meaning IconBattery charge Battery installationBattery strength Battery icon Turning the power on/off Battery replacementSetting the date and time Example 330 PM Making calls Redial featureAnswering calls Other featuresTo adjust the ringer volume when an outside call comes Auto talk featureHandset locator Adding entries to the phonebook Using the phonebookFinding and calling a phonebook entry Editing entries in the phonebookChain dial Handset settings Sub-menu Default setting Menu Guide to handset settingsNight mode Ringer setupRinger volume Changing ringtonesSelecting the standby mode display Display setupCall options Changing the display contrastOther options Resetting the handset to its default settingsTurning auto talk on/off Changing the handset PIN Personal Identification NumberHandset Settings Base unit Sub-menu Default setting Settings menu Guide to base unit settingsNight mode Changing the recall time Setting pause lengthStoring/changing emergency numbers Selecting area codes to be deleted automatically Setting call restrictionChanging the base unit PIN Personal Identification Number Resetting the base unit to its default settingsCaller list Using Caller ID serviceViewing the caller list and calling back Editing a caller’s phone number before calling back Call minderErasing caller information Storing caller information into the phonebookRegistering a handset to a base unit Operating additional unitsAdditional handsets Manual registrationCancelling a base unit Cancelling a handsetTurning the repeater mode on/off Increasing the range of the base unitTransferring calls between handsets Intercom between handsetsHandset 60 mm Screws Hooks Wall mountingCharacter entry modes Available character entriesExtended 2 character table O Extended 1 character table NCyrillic character table P Initial settings TroubleshootingProblem Cause & solution Telephone Useful Information Specifications PIN IndexPage Copyright Customer Support Centre Tel. No 272 Sales Department