Panasonic KX-TG1805NZ Troubleshooting, Initial settings, Problem Cause & solution

Page 34

Useful Information

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the AC adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.

Initial settings

Problem	Cause & solution
w is flashing.	LThe handset is not registered to the base unit.
	Register it (page 28).
	LThe handset is too far from the base unit. Move
	closer.
	LThe AC adaptor is not connected. Check the
	connections.

The handset display is blank.	LThe handset is not turned on. Turn the power on
	(page 9).

The handset will not turn on.	LMake sure that the batteries are installed correctly
	(page 8).
	LFully charge the batteries (page 8).
	LClean the charge contact and charge again (page
	8).

Image 34

Contents Model No. KX-TG1805NZ Introduction Making/Answering Calls Included accessories Accessory informationAdditional/replacement accessories General Battery cautionImportant information EnvironmentHandset Charge contact Phonebook Talk Navigator key Controls and displaysControls Base unit Charge contactDisplay icons ConnectionsDisplays Display Meaning IconBattery charge Battery installationBattery strength Battery icon Turning the power on/off Battery replacementSetting the date and time Example 330 PM Redial feature Making callsOther features Answering callsTo adjust the ringer volume when an outside call comes Auto talk featureHandset locator Finding and calling a phonebook entry Using the phonebookAdding entries to the phonebook Editing entries in the phonebookChain dial Guide to handset settings Handset settings Sub-menu Default setting MenuRinger volume Ringer setupNight mode Changing ringtonesCall options Display setupSelecting the standby mode display Changing the display contrastTurning auto talk on/off Resetting the handset to its default settingsOther options Changing the handset PIN Personal Identification NumberHandset Settings Guide to base unit settings Base unit Sub-menu Default setting Settings menuNight mode Changing the recall time Setting pause lengthStoring/changing emergency numbers Setting call restriction Selecting area codes to be deleted automaticallyResetting the base unit to its default settings Changing the base unit PIN Personal Identification NumberCaller list Using Caller ID serviceViewing the caller list and calling back Erasing caller information Call minderEditing a caller’s phone number before calling back Storing caller information into the phonebookAdditional handsets Operating additional unitsRegistering a handset to a base unit Manual registrationTurning the repeater mode on/off Cancelling a handsetCancelling a base unit Increasing the range of the base unitTransferring calls between handsets Intercom between handsetsHandset Wall mounting 60 mm Screws HooksAvailable character entries Character entry modesExtended 2 character table O Extended 1 character table NCyrillic character table P Initial settings TroubleshootingProblem Cause & solution Telephone Useful Information Specifications Index PINPage Customer Support Centre Tel. No 272 Sales Department Copyright