Panasonic KX-TG1805NZ Battery installation, Battery charge, Battery strength Battery icon

Page 8

Preparation

Battery installation

1Insert the batteries negative (T) terminal first.

2Close the handset cover.

Note:

LUse only rechargeable batteries (page 4).

Battery charge

Place the handset on the base unit for about 7 hours before initial use.

When charging, the battery icon is shown as follows.

When the batteries are fully charged, 5 remains on the display.

Note:

LIt is normal for the handset to feel warm during charging.

LIt takes 7 hours to fully charge the batteries, however, you can use the handset before the batteries are fully charged.

LClean the charge contacts (page 6) of the handset and base unit with a soft, dry cloth once a month, otherwise the batteries may not charge properly. Clean more often if the unit is exposed to grease, dust or high humidity.

Battery strength

Battery icon

Battery strength

 

 

5High

6Medium

7Low

When flashing: Needs to be charged.

Note:

LWhen 7flashes, recharge the handset batteries. 7 will continue to flash until the batteries have been charged for at least 15 minutes.

8

Image 8
Contents Model No. KX-TG1805NZ Introduction Making/Answering Calls Additional/replacement accessories Accessory informationIncluded accessories Battery caution Important informationGeneral EnvironmentControls and displays ControlsHandset Charge contact Phonebook Talk Navigator key Base unit Charge contactConnections DisplaysDisplay icons Display Meaning IconBattery strength Battery icon Battery installationBattery charge Setting the date and time Battery replacementTurning the power on/off Example 330 PM Redial feature Making callsOther features Answering callsHandset locator Auto talk featureTo adjust the ringer volume when an outside call comes Using the phonebook Adding entries to the phonebookFinding and calling a phonebook entry Editing entries in the phonebookChain dial Guide to handset settings Handset settings Sub-menu Default setting MenuRinger setup Night modeRinger volume Changing ringtonesDisplay setup Selecting the standby mode displayCall options Changing the display contrastResetting the handset to its default settings Other optionsTurning auto talk on/off Changing the handset PIN Personal Identification NumberHandset Settings Guide to base unit settings Base unit Sub-menu Default setting Settings menuNight mode Storing/changing emergency numbers Setting pause lengthChanging the recall time Setting call restriction Selecting area codes to be deleted automaticallyResetting the base unit to its default settings Changing the base unit PIN Personal Identification NumberViewing the caller list and calling back Using Caller ID serviceCaller list Call minder Editing a caller’s phone number before calling backErasing caller information Storing caller information into the phonebookOperating additional units Registering a handset to a base unitAdditional handsets Manual registrationCancelling a handset Cancelling a base unitTurning the repeater mode on/off Increasing the range of the base unitHandset Intercom between handsetsTransferring calls between handsets Wall mounting 60 mm Screws HooksAvailable character entries Character entry modesCyrillic character table P Extended 1 character table NExtended 2 character table O Problem Cause & solution TroubleshootingInitial settings Telephone Useful Information Specifications Index PINPage Customer Support Centre Tel. No 272 Sales Department Copyright