Panasonic KX-TG1850ALT operating instructions Ringer setup, Night mode

TG1850AL(e).book Page 28 Monday, December 6, 2004 9:10 PM

Base Unit Settings

		7		Enter the desired hour and minute you
Ringer setup
				wish to start this feature by selecting 2
				digits for each.
				LIf you use 12-hour time entry, select
Ringer volume
				“AM” or “PM” by pressing {*}
1 Press $(middle soft key).		8		repeatedly before entering the time.
2	Select Z, then press ,.			Enter the desired hour and minute you
3 Enter “0000” (default base unit PIN).				wish to end this feature by selecting 2
				digits for each.
	LIf you changed the PIN, enter it (page			LIf you use 12-hour time entry, select
	30).
4				“AM” or “PM” by pressing {*}
	Select “Ringer Setup”, then press			repeatedly before entering the time.
5	,.	9		Press ,.
	Select “Ringer Volume”, then press		10 Press {ih}.
	,.
6 Press {e} or {v} repeatedly to select
			Turning night mode on/off
	the desired volume.	1		Press $(middle soft key).
7	Press ,.
		2		Select Z, then press ,.
8	Press {ih}.
		3		Enter “0000” (default base unit PIN).
				LIf you changed the PIN, enter it (page
Night mode
				30).
Night mode allows you to select a block of
		4		Select “Ringer Setup”, then press
time during which the base unit will not ring
for outside calls. This feature is useful for				,.
		5		Select “Night Mode”, then press
times when you do not want to be disturbed,
for example, while sleeping. Night mode can				,.
be set independently for the handset (page		6		Select “On/Off”, then press ,.
23) and the base unit.
Set the date and time beforehand (page 14).		7		Select “On” or “Off”, then press ,.
		8		Press {ih}.
Setting the start and end time for night
mode			Setting the ring delay for night mode
1 Press $(middle soft key).			This setting allows the base unit to ring
2	Select Z, then press ,.		during night mode if the caller waits long
			enough. After the selected amount of time
3 Enter “0000” (default base unit PIN).			passes, the base unit will ring, useful when
	LIf you changed the PIN, enter it (page		someone urgently needs to speak with you.
	30).		If you select “No Ringing”, the base unit
4	Select “Ringer Setup”, then press		will not ring during night mode.
		1		Press $(middle soft key).
	,.
5	Select “Night Mode”, then press	2		Select Z, then press ,.
		3		Enter “0000” (default base unit PIN).
	,.
6	Select “Start/End”, then press ,.			LIf you changed the PIN, enter it (page
				30).

28