Panasonic KX-TG1850ALT Operating additional units, Registering a handset to a base unit

Page 43

TG1850AL(e).book Page 43 Monday, December 6, 2004 9:10 PM

Multi-unit Operation

Operating additional units

Additional handsets

Up to 6 handsets can be registered to a single base unit. Additional handsets will give you the freedom to, for example, have an intercom call with another handset while a third handset is on an outside call. See page 5 for information on ordering additional handsets.

Additional base units

Handsets can be registered to up to 4 base units, allowing you to add additional base units and extend the area in which your handset(s) can be used. If a handset moves out of range of its base unit when Autois selected on base unit selection (page 44), it will look for another base unit to make or receive calls. A base unit and the handsets it communicates with is called a “radio cell”.

Note:

LCalls will be disconnected when the handset moves from one radio cell to another.

LIntercom calls and call transfers are only possible between handsets in the same radio cell.

Registering a handset to a base unit

To register an additional handset to a base unit (easy registration)

The included handset and base unit are preregistered. After purchasing an additional handset, register it to the base unit. Ensure that the additional handset is switched on. If it is not on, press and hold {ih} for few seconds to turn the handset on.

1Lift the additional handset and press {ih} to put the handset in standby mode.

2Press and hold {x} on the base unit for about 3 seconds, until the registration tone sounds.

3Place the additional handset on the base unit. The registration tone continues to sound. With the handset still on the base unit, wait until a confirmation tone sounds and w stops flashing.

Note:

LIf an error tone sounds, or if w is still flashing, register the handset manually (manual registration; page 43).

LIf all registered handsets start ringing in step 2, press {x} to stop. Start again from step 1.

LCharge the batteries of your additional handset for about 7 hours before initial use.

LThis registration method cannot be used for handsets that have already been registered to a base unit. Register the handset manually (manual registration; page 43).

To register a handset to an additional base unit (manual registration)

You can register a handset to a base unit manually using the following method.

1Press $(middle soft key).

2Select Y, then press ,.

3Select Registration, then press ,2 times.

4Select a base unit number, then press

,.

LThis number is used by the handset as a reference only.

5Press and hold {x} on the base unit for about 3 seconds, until the registration tone sounds.

43

Image 43
Contents Model No. KX-TG1850AL Trademarks IntroductionFeature highlights Making/Answering Calls Model No Description Accessory informationIncluded accessories Additional/replacement accessoriesEnvironment Battery cautionImportant information GeneralInstructions to customer InstallationService difficulties Controls Controls and displaysDisplays Menu icons Menu Menu/feature IconSoft key icons Action Key Icon Soft Action Key Icon ConnectionsBattery charge Battery installationBattery strength Battery icon Battery replacement Screen saver modeTurning the power on/off Example 330 PM Setting the date and timeMaking calls Redial featureMute Other featuresVoice enhancer To erase numbers in the redial listAnswering calls Finding and calling a phonebook entry Using the phonebookAdding entries to the phonebook CategoriesErasing entries from the phonebook Editing entries in the phonebookOne touch dial Copying all entries Making a call using a one touch dial keyChain dial Copying one entryHandset settings Sub-menu Default setting Menu Guide to handset settingsRinger volume Time settingsRinger setup AlarmSetting the ring delay for night mode Night modeSetting the start and end time for night mode Turning night mode on/offDisplay Display setupSelecting the standby mode Selecting a display colourCall options Changing the LetterWise language Resetting the handset to its default settingsTurning keytones on/off Base unit Sub-menu Default setting Settings menu Guide to base unit settingsNight mode Selecting area codes to be deleted automatically Setting pause lengthChanging the recall time Storing/changing emergency numbersSetting call restriction Resetting the base unit to its default settings Category features for Caller ID subscribers Using Caller ID serviceCall waiting and Caller ID compatible Erasing caller information Caller listViewing the caller list and calling back Editing a caller’s phone number before calling backStoring caller information into the phonebook Centre numbers Using SMS ShortMessage Service Changing SMS messageWriting and sending a new message Sending a messageErasing saved messages Receiving a messageSending a saved message Editing and sending a saved messageStoring the sender’s number in the phonebook Reading a received messageReplying to a message Erasing received messagesCreating private mailboxes Guide to SMS settingsChanging private mailbox settings SMS settings Default SettingStoring the PBX line access number for PBX users only Character entry modes Available character entries for SMSLetterWise character table for English LThe following are used for both uppercase and lowercase Additional base units Operating additional unitsRegistering a handset to a base unit Additional handsetsCancelling a base unit Cancelling a handsetSelecting a base unit Increasing the range of the base unit Turning the repeater mode on/offHandset TG1850ALe.book Page 46 Monday, December 6, 2004 910 PM 60 mm Screws Wall mountingAlphabet character table ABC Available character entriesExtended 2 character table O Cyrillic character table P Initial settings TroubleshootingProblem Cause & solution Telephone Redial the number manually SMS Short Message Service Specifications PIN IndexTG1850ALe.book Page 57 Monday, December 6, 2004 910 PM TG1850ALe.book Page 58 Monday, December 6, 2004 910 PM TG1850ALe.book Page 59 Monday, December 6, 2004 910 PM Sales Department Panasonic Australia Pty. Limited Customer Support Centre Tel. NoCopyright

KX-TG1850ALT specifications

The Panasonic KX-TG1850ALT is a highly efficient cordless phone designed to meet the needs of users seeking both functionality and reliability in their communication devices. With a stylish design and robust features, it has become a popular choice for home and small office environments.

One of the standout features of the KX-TG1850ALT is its 1.8-inch illuminated LCD screen, which provides easy readability and enhances user convenience. The screen displays caller ID, call logs, and other essential information, making it user-friendly for people of all ages. The phone's ergonomic design and lightweight build ensure comfortable handling during long conversations.

The KX-TG1850ALT is equipped with a range of advanced technologies, including DECT 6.0 technology. This innovation ensures a secure and interference-free connection, along with extended range and improved audio quality. Users will appreciate the clear sound quality provided by this technology, which significantly enhances the overall calling experience.

Another key feature of the KX-TG1850ALT is its digital answering system. This built-in functionality allows users to receive and manage messages conveniently. The answering machine can store up to 18 minutes of messages, ensuring that you won't miss important communications. Users can access their messages easily from anywhere, providing peace of mind even when away from home.

For added convenience, the KX-TG1850ALT comes with a phonebook that can store up to 50 contacts. This feature enables users to save frequently dialed numbers and access them with ease. The phone also supports caller ID, allowing users to screen incoming calls and manage their communications more efficiently.

The phone's energy-saving capabilities are also noteworthy. It comes with a power-saving mode that minimizes energy consumption while the phone is in standby, contributing to a more environmentally friendly choice for consumers. Furthermore, it offers a long battery life, with up to 10 hours of talk time and up to 170 hours of standby time, which ensures that users can rely on it throughout the day.

In conclusion, the Panasonic KX-TG1850ALT is a feature-rich cordless phone that balances style, functionality, and advanced technology. With its user-friendly interface, superior audio quality, and smart features like a digital answering system and extensive phonebook, it meets the needs of modern communication while ensuring reliability and ease of use.