Panasonic KX-TG1831NZ Error messages, Troubleshooting, Memory Full, You must first subscribe

Page 26

Useful Information

Error messages

Error message	Cause & solution
Memory Full	LThe handset’s phonebook memory is full. Erase
	unnecessary entries (page 13).
You must first subscribe	LYou must subscribe to Caller ID service. Once you
to Caller ID.	receive caller information after subscribing to Caller
	ID service, this message will not be displayed.

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the AC adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.

Telephone

Problem	Cause & solution
w is flashing.	LThe handset is not registered to the base unit.
	Register it (page 21).
	LThe handset is too far from the base unit. Move
	closer.
	LThe AC adaptor is not connected. Check the
	connections.
	LYou are using the handset or base unit in an area
	with high electrical interference. Place the handset
	and base unit away from interference sources, such
	as antennas and mobile phones.
The handset display is blank.	LThe handset is not turned on. Turn the power on
	(page 9).
The handset will not turn on.	LMake sure that the batteries are installed correctly
	(page 8).
	LFully charge the batteries (page 8).
	LClean the charge contacts and charge again (page
	8).
I have changed the display	LChange the display language (page 10).
language to a language I cannot
read.

26

Image 26

Contents Model No. KX-TG1831NZ Introduction Making/Answering Calls Accessory information Included accessoriesGeneral Battery cautionImportant information EnvironmentControls Important noticeBase unit Charge contact B x Ringer DisplaysConnections Display icons Display Meaning iconLocation Battery chargeIf you subscribe to an Adsl service Power on Turning the power on/offBattery strength Battery icon Power offDisplay language Date and timeMaking calls Redial featureOther features EraseTo adjust the handset ringer volume when receiving a call Pause button for PBX/long distance service usersAuto talk feature Answering callsFinding and calling a handset phonebook entry Handset phonebookAdding entries to the handset phonebook Editing entries in the handset phonebookChain dial Handset settings Handset Settings Call Options Recall/Flash Base unit settingsRepeater Mode Area Code Call Restrict Other Options Base Unit PINOK iBase Unit Setup Call Options Call Restrict Setting call restrictionOK iBase Unit Setup Call Options Area Code Call optionsViewing the caller list and calling back Using Caller ID serviceCaller list OK iCaller ListStoring caller information into the handset phonebook Editing a caller’s phone number before calling backErasing caller information OK iEdit and CallRegistering a handset to the base unit OK iHandset Setup Registration Register H.setOperating additional units Additional handsetsOKiBase Unit Setup Other Options Repeater Mode Cancelling a handsetOK iBase Unit Setup Increasing the range of the base unitTo complete the call transfer, press Character entry Characters available in each character entry modeWhen the unit displays the character entry screen Character entry modesCyrillic character table P Extended 1 character table NExtended 2 character table O Memory Full Error messagesTroubleshooting You must first subscribeProblem Cause & solution LWipe the battery ends S, T and the unit contacts Specifications Index PINPage Customer Support Centre Tel. No 272 Sales Department Copyright