Preparation
Charge contact
Note:
LIt is normal for the handset to feel warm during charging.
LIf you want to use the unit immediately, charge the batteries for at least 15 minutes.
LClean the charge contacts of the handset and base unit with a soft, dry cloth once a month, otherwise the batteries may not charge properly. Clean more often if the unit is exposed to grease, dust or high humidity.
Battery strength
Battery icon | Battery strength |
5 | High |
6 | Medium |
7Low
When flashing: Needs to be charged.
Panasonic
Operation | Operating time |
In continuous use | 17 hours max. |
In continuous | 180 hours max. |
standby mode |
|
Note:
LIt is normal for batteries not to reach full capacity at the initial charge. Maximum battery performance is reached after a few
complete cycles of charge/discharge (use).
LActual battery performance depends on a combination of how often the handset is in use and how often it is not in use (standby).
LBattery operating time may be shortened over time depending on usage conditions and ambient temperature.
LEven after the handset is fully charged, the handset can be left on the base unit without any ill effect on the batteries.
LThe battery strength may not be displayed correctly after you replace the batteries. In this case, place the handset on the base unit and charge for at least 7 hours.
Turning the power on/off
Power on
Press {ih} for about 1 second.
Power off
Press {ih} for about 2 seconds.
Symbols used in these operating instructions
Symbol | Meaning |
{j/OK} | Press {j/OK}. |
iProceed to the next operation.
“” Select the words in quotations shown on the display (e.g.,
“Handset Setup”) by pressing {^} or {V}.
9