Panasonic KX-TG1831NZ operating instructions Specifications

Page 29

Useful Information

Specifications

Standard:

GAP (Generic Access Profile)

Number of channels: 120 Duplex Channels

Frequency range: 1.88 GHz to 1.9 GHz

Duplex procedure:

TDMA (Time Division Multiple Access)

Channel spacing: 1,728 kHz

Bit rate:

1,152 kbit/s

Modulation:

GFSK (Gaussian Frequency Shift Keying)

RF transmission power: Approx. 250 mW

Power source:

220–240 V, 50 Hz

Power consumption: Base unit:

Standby: Approx. 1.9 W

Maximum: Approx. 6.8 W

Operating conditions:

5°C–40 °C, 20 %–80 % relative air humidity (dry)

Dimensions:

Base unit: Approx. 60 mm 173 mm 105 mm

Handset: Approx. 155 mm 48 mm 34 mm

Mass (weight):

Base unit: Approx. 220 g

Handset: Approx. 140 g

Note:

LSpecifications are subject to change.

LThe illustrations used in these operating instructions may differ slightly from the actual product.

29

Image 29
Contents Model No. KX-TG1831NZ Introduction Making/Answering Calls Included accessories Accessory informationImportant information Battery cautionGeneral EnvironmentImportant notice ControlsConnections DisplaysBase unit Charge contact B x Ringer Display icons Display Meaning iconLocation Battery chargeIf you subscribe to an Adsl service Battery strength Battery icon Turning the power on/offPower on Power offDate and time Display languageOther features Redial featureMaking calls EraseAuto talk feature Pause button for PBX/long distance service usersTo adjust the handset ringer volume when receiving a call Answering callsAdding entries to the handset phonebook Handset phonebookFinding and calling a handset phonebook entry Editing entries in the handset phonebookChain dial Handset settings Handset Settings Repeater Mode Base unit settingsCall Options Recall/Flash Area Code Call Restrict Other Options Base Unit PINOK iBase Unit Setup Call Options Area Code Setting call restrictionOK iBase Unit Setup Call Options Call Restrict Call optionsCaller list Using Caller ID serviceViewing the caller list and calling back OK iCaller ListErasing caller information Editing a caller’s phone number before calling backStoring caller information into the handset phonebook OK iEdit and CallOperating additional units OK iHandset Setup Registration Register H.setRegistering a handset to the base unit Additional handsetsOK iBase Unit Setup Cancelling a handsetOKiBase Unit Setup Other Options Repeater Mode Increasing the range of the base unitTo complete the call transfer, press When the unit displays the character entry screen Characters available in each character entry modeCharacter entry Character entry modesCyrillic character table P Extended 1 character table NExtended 2 character table O Troubleshooting Error messagesMemory Full You must first subscribeProblem Cause & solution LWipe the battery ends S, T and the unit contacts Specifications PIN IndexPage Copyright Customer Support Centre Tel. No 272 Sales Department