Panasonic KX-TG1612BX Battery charging, During a power failure, Icon Battery level

Page 8

TG161xBX(e).book Page 8 Wednesday, October 19, 2011 8:45 AM

Getting Started

Battery charging

Charge for about 7 hours.

Note when setting up

Note for connections

LThe AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.)

LThe AC adaptor should be connected to a vertically oriented or floor-mounted AC outlet. Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight of the adaptor may cause it to become disconnected.

During a power failure

The unit will not work during a power failure. We recommend connecting a corded-type telephone (without AC adaptor) to the same telephone line or to the same telephone line jack using a T-adaptor.

Note for battery installation

LUse the supplied rechargeable batteries. For replacement, we recommend using the Panasonic rechargeable batteries noted on page 3, 5.

LWipe the battery ends (S, T) with a dry cloth.

LAvoid touching the battery ends (S, T) or the unit contacts.

Note for battery charging

LIt is normal for the handset to feel warm during charging.

LClean the charge contacts of the handset, base unit, and charger with a soft and dry cloth once a month. Before cleaning the unit, disconnect from power outlets and any telephone line cords. Clean more often if the unit is exposed to grease, dust, or high humidity.

Battery level

Icon

Battery level

5High

6Medium

7Low

8Needs charging.

Panasonic Ni-MH battery performance (supplied batteries)

Operation

Operating time

In continuous use

15 hours max.

Not in use

170 hours max.

(standby)

 

Note:

LIt is normal for batteries not to reach full capacity at the initial charge. Maximum battery performance is reached after a few complete cycles of charge/discharge (use).

LActual battery performance depends on usage and ambient environment.

LEven after the batteries are fully charged, the handset can be left on the base unit or charger without any ill effect on the batteries.

LThe battery level may not be displayed correctly after you replace the batteries. In this case, place the handset on the base unit or charger and let it charge for at least 7 hours.

8

Image 8
Contents Digital Cordless Phone Thank you for purchasing a Panasonic productTable of Contents Accessory information Supplied accessoriesAdditional/replacement accessories Model compositionFor your safety Important safety instructions BatteryFor best performance Base unit location/avoiding noiseRoutine care SpecificationsOther information Setting up Battery installationConnections Correct WrongBattery charging During a power failureBattery level Icon Battery levelControls DisplayHandset Base unitTurning the power on/off Initial settingsDialling mode Display languageMaking calls Answering callsUseful features during a call Handset phonebook Adding entriesErasing entries Finding and calling from a Phonebook entry Chain dialTG161xBXe.book Page 14 Wednesday, October 19, 2011 845 AM Main menu Sub-menu Programmable settingsProgramming by scrolling through the display menus Setup Language English Contrast Alarm Special programmingUsing Caller ID service Caller ID featuresCaller list Viewing the caller list and calling backErasing caller information Storing caller information to the phonebookErase or Erase All s Save TEL No. sj/OKVoice mail service Intercom Handset locatorTransferring calls, conference calls Making an intercom callCharacter entry Character entry modesCyrillic character table P Extended 1 character table pExtended 2 character table O Error messages TroubleshootingGeneral use Memory FullMaking/answering calls, intercom Programmable settingsBattery recharge Caller ID Liquid damageRegistering a handset to the base unit Deregistering a handsetChanging the base unit PIN Personal Identification Number Register HS sj/OKWall mounting Base unit ChargerIndex TG161xBXe.book Page 30 Wednesday, October 19, 2011 845 AM TG161xBXe.book Page 31 Wednesday, October 19, 2011 845 AM For your future reference