TG161xBX(e).book Page 24 Wednesday, October 19, 2011 8:45 AM
Useful Information
Error messages
Display message | Cause/solution |
Memory Full | L The phonebook memory is full. Erase unwanted entries (page 13). |
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s AC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the handset.
General use
Problem | Cause/solution |
The handset does not turn on even | L Place the handset on the base unit or charger to turn |
after installing charged batteries. | on the handset. |
The unit does not work. | L Make sure the batteries are installed correctly (page |
| 7). |
| L Fully charge the batteries (page 8). |
| L Check the connections (page 7). |
| L Unplug the base unit’s AC adaptor to reset the unit |
| and turn off the handset. Reconnect the adaptor, turn |
| on the handset and try again. |
| L Remove the batteries from the handset and install |
| again. |
| L The handset has not been registered to the base |
| unit. Register the handset (page 27). |
The handset display is blank. | L The handset is not turned on. Turn the power on |
| (page 10). |
I cannot hear a dial tone. | L Make sure that you are using the supplied telephone |
| line cord. Your old telephone line cord may have a |
| different wiring configuration. |
| L The base unit’s AC adaptor or telephone line cord is |
| not connected. Check the connections. |
| L Disconnect the base unit from the telephone line and |
| connect the line to a known working telephone. If the |
| working telephone operates properly, contact our |
| service personnel to have the unit repaired. If the |
| working telephone does not operate properly, |
| contact your service provider/telephone company. |
I cannot use the intercom feature.*1 | L This feature is shared between the handsets. |
| Although the handset displays “Intercom”, this |
| feature is not available for this model. |
*1 |
|
24