Panasonic KX-TG2721AL, KX-TG2722AL Error messages, Troubleshooting, General use

Page 34

Useful Information

Error messages

Display message

Error

Failed

Incomplete

Memory Full

Messages Full

No link to base. Reconnect AC adaptor.

Cause/solution

RRecording was too short. Try again.

RPhonebook copy failed (page 16). Confirm the other handset (the receiver) is in standby mode and try again.

RThe receiver’s phonebook memory is full. Erase the unwanted phonebook entries from the other handset (the receiver) and try again.

RThe phonebook memory is full. Erase unwanted entries (page 16).

RMessage memory is full. Erase unwanted messages (page 25, 26).

RThe handset has lost communication with the base unit. Move closer to the base unit and try again.

RUnplug the base unit’s AC adaptor to reset the unit. Reconnect the adaptor and try again.

RThe handset’s registration may have been cancelled. Re-register the handset (page 38).

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the base unit’s AC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the handset.

General use

Problem

The handset does not turn on even after installing charged batteries.

The unit does not work.

The handset display is blank.

Cause/solution

RPlace the handset on the base unit or charger to turn on the handset.

RMake sure the batteries are installed correctly (page 9).

RFully charge the batteries (page 9).

RCheck the connections (page 9).

RUnplug the base unit’s AC adaptor to reset the unit and turn off the handset. Reconnect the adaptor, turn on the handset and try again.

RThe handset has not been registered to the base unit. Register the handset (page 38).

RThe handset is not turned on. Turn the power on (page 12).

34

TG2721_22AL(en)_0730_ver001.pdf 34

2012/07/30 16:53:05

Image 34

Contents Digital Cordless Answering System Thank you for purchasing a Panasonic productTable of Contents Supplied accessories Accessory informationModel composition Accessory item Additional/replacement accessoriesModel number For your safety For best performance Important safety instructionsBattery General noticesEnvironment SpecificationsOther information Routine careOperating conditions Battery charging Setting upBattery installation ConnectionsIcon Battery level During a power failureBattery level Operation Operating timeHandset ControlsBase unit Display Turning the power on/offInitial settings Display languageOne touch eco mode Making calls Answering callsMute Useful features during a callHold Recall/flashHandset phonebook Copying phonebook entriesCopying all entries Scrolling through the display menus Programmable settingsPlay Greeting Default*1 Main menu Sub-menuLevel Special programming AlarmStoring an area code to be deleted automatically Increasing the range of the base unit Setting the repeater modeMbN Base Unit Setup a M N MbN Repeater Mode a M N Dect repeaterCaller list Using Caller ID serviceCaller ID features Call waiting and Caller ID compatibleErasing caller information Viewing the caller list and calling backEditing a caller’s phone number before calling back Storing caller information to the phonebookGreeting message Answering systemTurning the answering system on/off Memory capacity including your greeting messageListening to messages using the base unit Operating the answering system Listening to messages using the handsetRemote operation Calling back Caller ID subscribers onlyRemote commands Remote access codeUsing the answering system remotely Voice guidanceNumber of rings before the unit answers a call Answering system settingsFor service provider voice mail subscribers Caller’s recording timeAnswering System Voice mail service Handset locator Intercom Transferring calls, conference calls Character entry When the unit displays the character entry screenCharacter entry modes Extended 2 character table Extended 1 character tableCyrillic character table Troubleshooting Error messagesGeneral use Battery recharge Programmable settingsMaking/answering calls, intercom Caller ID Answering system Liquid damageDeregistering a handset Registering a handset to the base unitChanging the base unit PIN Personal Identification Number Wall mounting Wall mounting templateIndex 2012/07/30 2012/07/30 2012/07/30 For your future reference Sales Department

Related manuals

Manual 44 pages 57.33 Kb