Site Survey Mode (PBX option only)
This function can be used to measure the transmission quality, and identify problematic transmission areas of the repeater installation. This function can be used when registered or
•Ensure the repeater is powered OFF before starting.
•To activate the site survey mode, press and hold the switch, then Power ON, while continuing to hold the switch.The red LED will flash slowly.
•Continue to press and hold down the switch for 5 seconds. When the switch is released the green LED flashes fast and the red LED will go OFF.
•Activate Site Survey function on handset. The Repeater CSID is 1234567890.
•To change the site survey channel, press the
switch the required number of times (i.e twice for channel 2). The default site survey channel is 1.
•The red LED will flash the number of times corresponding with the channel selected. The channel between 0 and 9 can be selected by pressing the switch the corresponding number of times (channel 0 = 10 times) At channel 9, one switch press will change the channel back to 0
•Site survey mode is now operational.
•To turn OFF the site survey mode, Power OFF then repeater, then Power ON.
•Please note :1) The repeater site survey mode works independently from the PBX cell station. This means that the PBX cell station does not have to be placed into site survey mode.
2)When using more than 1 repeater in site survey mode simultaneously, please ensure repeaters are set to different channels.
For more information on how to use site survey, and for a list of compatible handsets, please refer to the appropriate PBX Installation manual.
12 Operating Instructions