Before Requesting Help
| Problem | Possible Cause | Solution |
|
|
|
|
|
|
| No function | No power | Check AC cord is plugged in |
|
| (LED not lit) | Not turned on | Check AC adaptor is switched on |
|
|
|
|
|
|
| Cannot register | Out of range of base | Move repeater closer to base unit |
|
| (Green LED flashes) or cell station, or base | or cell station |
| |
|
| unit cell station not | Repeat registration procedure |
|
|
| powered | Check base unit / cell station is on |
|
|
|
|
|
|
| Handset beeping | Verification tone on | Switch off verification tone |
|
|
|
|
|
|
| Poor audio quality | Out of range of base | Move repeater closer to base unit/ |
|
|
|
| Cell Station |
|
|
| Out of range of handset | Move handset closer to repeater |
|
|
|
|
|
|
A ringing call | Delay when moving from |
suddenly stops | cell station to repeater |
when moving from | during incoming ring |
zone to zone | in group ring mode |
(PBX option only) |
|
Answer the call before moving beyond repeater/cell station boundary
When talking and moving from zone to zone, you hear an alarm or continuous noise, or your call is disconnected.
The new zone is in ‘busy condition’, so handover cannot occur.
Return to original zone and continue your call
Operating Instructions 15