Avaya IPTM96-CM601 manual Configure Rtcp Monitoring, Secs to

5.4. Configure RTCP Monitoring

To allow PROGNOSIS IP Telephony Manager to monitor the quality of IP calls, configure Communication Manager to send RTCP reporting to the IP address of the PROGNOSIS server. This is done through the SAT interface.

Step	Description
1. Enter the change system-parameters ip-options command. In the RTCP MONITOR
	SERVER section, set Server IPV4 Address to the IP address of the PROGNOSIS IP
	Telephony Manager server. Set IPV4 Server Port to 5005 and RTCP Report Period
	(secs) to 5.
	change system-parameters ip-options				Page 1 of 3
		IP-OPTIONS SYSTEM PARAMETERS
	IP MEDIA PACKET PERFORMANCE THRESHOLDS
	Roundtrip Propagation Delay (ms)			High: 800	Low: 400
	Packet Loss (%)			High: 40	Low: 15
	Ping Test Interval (sec): 20
	Number of Pings Per Measurement Interval: 10
	Enable Voice/Network Stats? n
	RTCP MONITOR SERVER
	Server IPV4 Address:	10.1.10.124		RTCP Report Period(secs): 5
	IPV4 Server Port:		5005
	Server IPV6 Address:
	IPV6 Server Port: 5005
	AUTOMATIC TRACE ROUTE ON
	Link Failure? y
				H.323 IP ENDPOINT
	H.248 MEDIA GATEWAY			Link Loss Delay Timer (min): 5
	Link Loss Delay Timer (min): 5			Primary Search Time (sec): 75
		Periodic Registration Timer (min): 20
		Short/Prefixed Registration Allowed? N

2.Enter the change ip-network-regionn command, where n is IP network region number to be monitored. On Page 2, set RTCP Reporting Enabled to y and Use Default Server Parameters to y.

Note: Only one RTCP MONITOR SERVER can be configured per IP network region.

	change ip-network-region 1	Page 2 of 20
	IP NETWORK REGION
	RTCP Reporting Enabled? y
	RTCP MONITOR SERVER PARAMETERS
	Use Default Server Parameters? Y
3. Repeat Step 2 for all IP network regions that are required to be monitored.

JC; Reviewed:	Solution & Interoperability Test Lab Application Notes	14 of 30
SPOC 6/16/2011	©2011 Avaya Inc. All Rights Reserved.	IPTM96-CM601