Uniden UH047sx manual Getting Started, Battery Installation, To install the batteries

Page 3

GETTING STARTED

Uniden does not represent this product to be waterproof. Do not expose this product to Rain or Moisture.

BATTERY INSTALLATION

Your uh047sx unit uses the included NiMH battery pack for power. The unit can be powered with optional 4 AAA ALKALINE batteries.

If you don't use the uh047sx for long periods, Uniden recommend removing the batteries. The uh047sx is designed to retain the previous user settings. This feature will continue to use a small amount of battery power while the unit is switched off.

To avoid damage to the unit do not mix old and new batteries.

To install the batteries:

1. Make sure your radio is off.

2. Release the battery cover clip, then remove the battery cover.

3. Insert NiMH battery pack according to the orientation on the battery pack.

OR

Insert 4 AAA ALKALINE batteries (not included) according to the polarity symbols inside the battery compartment.

4. Align the battery cover tabs with the uh047sx tab holes then replace the cover clip.

Do not charge alkaline or non rechargeable batteries.

(2)

Image 3
Contents Uh047sx Included in Your Package Control & IndicatorsBattery Installation To install the batteriesGetting Started User Licence Information Installing the Charge CradleTo attach the belt clip LOW Battery AlertBelt Clip Back LightOperation Selecting a Channel To use monitor Automatic Squelch FeatureMonitor ScanningOperation with the aid of a Repeater DCS Ctcss & DCSVOX Transmitting a Call ToneTo select a call tone To set BCL ON/OFF Priority Scan ChannelScan Channel Memory To set a priority scan channelPlease follow these guidelines for channel use in Australia UHF CB Channels & FrequenciesCtcss & DCS Code List Uniden UH047SX UHF CB Tranceiver Radio WarrantyUniden Australia Pty Limited/Uniden New Zealand Limited