Uniden UH039P manual Getting Started, Battery Installation, Installing the Charge Cradle

Page 3

GETTING STARTED

Uniden does not represent this product to be waterproof. Do not expose this product to Rain or Moisture.

BATTERY INSTALLATION

Your UH039P unit uses the included NiMH battery pack for power. The unit can be powered with optional 4 AAA ALKALINE batteries.

OLDNEW

To avoid damage to the unit do not mix old and new batteries.

To install the batteries:

1. Make sure your radio is off.

2. Remove the battery compartment

door by pressing the tab at the bottom of the compartment door, allowing the

door to be removed.

3. Insert NiMH battery pack according to

the orientation on the battery pack. OR Insert 4 AAA ALKALINE batteries (not

included) according to the polarity

symbols inside the battery compartment.

4. Replace the battery cover.

Do not charge alkaline or non rechargeable batteries.

INSTALLING THE CHARGE CRADLE

￿ Plug the AC adaptor into the rear of the charge cradle and into the mains power.

2

Image 3
Contents UH039P Included in Your Package Control & IndicatorsBattery Installation Installing the Charge CradleGetting Started Belt Clip LOW Battery AlertOperation Power ON/OFFVolume Adjusting the KEY BeepsTo Transmit and Receive Selecting ChannelMonitor Automatic Squelch FeatureOperation with the aid of a Repeater To Operate in Duplex Mode RepeatersScanning VOX Reply DelayUHF Channels & Frequencies Uniden UH039P UHF CB Radio Warranty