For desktop use | For wall mount use |
DESK
DESK
WALL
DESK
WALL WALL
WALL
DESK
2.Plug the AC adapter into a standard 120V AC power outlet, and connect the telephone cord to a standard telephone wall jack.
3.If you are mounting the phone on the wall, place the mounting slots over the pins on the wall plate; slide the base down to lock it into place.
Test the Connection
Pick up the corded handset from the base. You should hear a dial tone and the display on the base should say Talk. When you get a dial tone, make a quick test call.
If... | Try... |
|
|
the display says Check TEL Line or you | checking the connection between the base |
don’t hear a dial tone | and the phone jack. |
|
|
you keep hearing a dial tone | changing to pulse dialing. |
|
|
Changing to Pulse Dialing
Your phone uses tone dialing by default. If your phone company uses pulse dialing, you need to change your phone’s dial mode.
1.Press Menu on the base or Menu/Select from the cordless handset and choose Global Setup.
2.Select Dial Mode then Pulse. You’ll hear a confirmation tone.
To send DTMF tones during a call (e.g., for an automated response system), press * to temporarily switch to tone dialing. When you hang up, the phone automatically returns to pulse dialing.
Set Up the Accessory Handsets
Install and Charge the Battery
1. Unpack all handsets, battery packs, and battery covers.
If you need to remove a cover, press in on the notch and slide the cover down and off.
2. Line up the battery connector with the jack inside the handset; the connector only fits one way.
3.Push the connector in until it clicks into place; tug gently on the wires to make sure the battery is securely connected.
4.Replace the battery cover and slide it into place.
Connect the Charger
1.Use an AC adapter to connect the power jack on each charger to a regular indoor (120V AC) power outlet.
4 - English