Kenwood TK-3130 instruction manual Charging the Battery Pack

Page 11

CHARGING THE BATTERY PACK

Initially charging the battery pack after purchase or extended storage (greater than 2 months) will not bring the battery pack to its normal operating capacity. After repeating the charge/ discharge cycle two or three times, the operating capacity will increase to normal.

◆Do not recharge the battery pack if it is already fully charged. Doing so may cause the life of the battery pack to shorten or the battery pack may be damaged.

◆After recharging the battery pack, disconnect it from the charger. Charging the battery pack for more than 5 days may reduce the battery pack life due to overcharging.

Note:

◆The ambient temperature should be between 41°F and 104°F (5°C and 40°C) while charging is in progress. Charging outside this range may not fully charge the battery.

◆Always switch OFF the transceiver equipped with a battery pack before charging. Using the transceiver while charging its battery pack will interfere with correct charging.

◆The battery pack life is over when its operating time decreases even though it is fully and correctly charged. Replace the battery pack.

6

Image 11
Contents TK-3130 Thank YOU FCC License Information Iii Contents Unpacking and Checking Equipment Orientation Antenna Power switch/ Volume control Menu keyDisplay Preparation INSTALLING/ Removing Batteries Charging the Battery Pack Page INSTALLING/ Removing the Belt Hook Getting Started Switch the Power onMake a Call Press the or key to select your desired value Quiet TALK/ Digital Quiet TalkScanning the Channels Revert Channel Monitoring a Channel To stop transmitting, stop speaking Voice Activated Control VOXPage Page Voice Scrambler Operating Features Display Illumination TIME-OUT Timer Battery Power Saver Battery Indicator Call Tones Call Alert Busy Channel Lockout FCC Warning Safety Information OFF QT TONES/ DQT CodesDQT Frequency Transmit/ Receive Color/Code Channel Frequency ChartProblem Solution Troubleshooting Guide