Kenwood TK-3130 instruction

To enjoy the VOX function, take the time to properly adjust the VOX Gain. This level controls the VOX circuit to detect the presence or absence of your voice.

1Turn the transceiver power OFF.

2Press and hold the MENU key while turning the transceiver power ON (for 1 second).

3Press the ▲ or ▼ key to select “GL”.

4Press the MENU key to select “GL-OF” (VOX function is off) or “GL-1” (VOX gain level 1) to “GL-3” (VOX gain level 3).

• While adjusting the VOX Gain, the LED lights orange.

Note: Setting the VOX gain to OFF deactivates VOX. In order to transmit with VOX turned off, you must use the PTT switch.

5Press the PTT, MON, or CAL key to exit Menu Mode.

If the transceiver returns to receive mode too quickly after you stop speaking, the end of your message may not be transmitted. To avoid this, select an appropriate delay time that allows your entire message to be transmitted. However, do not make the delay overly long.

1Turn the transceiver power OFF.

2Press and hold the MENU key while turning the transceiver power ON (for 1 second).

3Press the ▲ or ▼ key to select “dY”.

4Press the MENU key to select “dY-0.1” (hold for 100 ms), “dY-0.3” (300 ms), “dY-0.5” (500 ms), “dY-1.0” (1 second), “dY-1.5” (1.5 seconds), or “dY-3.0” (3 seconds).

5Press the PTT, MON, or CAL key to exit Menu Mode.