Sheet 5 | Cooper Lighting IMI-597 manual

INSTALLATION INSTRUCTIONS

IMPORTANT: READ CAREFULLY BEFORE INSTALLING FIXTURE.

RETAIN FOR FUTURE REFERENCE.

Flite

Sheet 5 of 8

8/31/04 IMI-597

WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing or servicing.

6a. Attach the Pole Clamp (Single Head) -

Attach the POLE CLAMP to the LOWER FLITE ARM using the six (6) 3/8-16 x 0.75” screws provided as depicted in Figure 6a. Do not tighten the screws completely; leave approximately 1/8” to 1/4” gap between the two parts. This will allow these parts to slip over the pole with no interference.

Fig. 6a

WARNING

Risk of Personal Injury

Fixture may become damaged and/or unstable if not installed properly

Tighten all fixture components to their recommended torque values

Pole Clamp

6b. Attach the Pole Clamp (Dual Head) -

Attach the two (2) LOWER FLITE ARM using the six (6) 3/8-16 x 0.75” screws provided as depicted in Figure 6b. Do not tighten the screws completely; leave approximately 1/8” to 1/4” gap between the two parts. This will allow these parts to slip over the pole with no interference.

NOTE: Pole Clamps (2) and One set of six (6) 3/8 - 16 x 0.75” screws are not necessary for this assembly. Discard if desired.

Fig. 6b

These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.

Customer First Center • 1121 Hwy 74 South • Peachtree City, GA 30269 IMI-597 AVU040197