Uniden EXS9110 owner manual Wall Installation, Standard wall plate mounting

Page 5

HINT

Before using your phone, fully charge the Nickel- Cadmium battery pack for 15-20 hours.

7) Attach the desktop stand to the base.

8)Set the base on a desk or tabletop and place the handset into the base

as shown. Then, raise the antenna to a vertical position.

CAUTION

Place the power cord so that it does not create a trip hazard or where it could become chafed and create a fire or electrical hazard.

WALL INSTALLATION

▼Standard wall plate mounting

This phone can be mounted on any standard AT&T or GTE wall plate.

1)Remove the wall mount adapter from the notches at the top of

the base.

2)Rotate the wall mount adapter

180 degrees and snap it into place at the bottom of the base.

4

Image 5

Contents Contents Introduction TIP TIP DESK/TABLETOP InstallationStandard wall plate mounting Wall InstallationDo not use an outlet controlled by a wall switch Direct wall mounting VAC wall outlet Page Installing the Handset Battery Pack Charging optional battery packs Charging the Battery PackInitial battery charging Low battery indicator Cleaning the Battery ContactsAdjusting the Ringer Controls Setting the PULSE/TONE SwitchHandset ringer volume Handset earpiece volumeTo remove the beltclip Installing the BeltclipTo attach the beltclip Automatic Digital Code Security Headset InstallationFlash and Call Waiting Making and Receiving CallsDialing with Memory Features Adjusting Volume During a CallUsing the memory location features Storing a Phone Number in MemoryTraveling OUT-OF-RANGE Chain DialingMute Tone RedialQuick Reference Chart TroubleshootingProblem Suggestion N E R a L Specifications