Uniden XCA550/55 Direct Wall Mounting, TEL Line jack on the Base Unit

Page 11

3.Plug one end of the short telephone cord into the

TEL LINE jack on the Base Unit.

4.Place the telephone cord inside the molded channel on the bottom of the Base Unit.

Then plug the other end of the telephone cord into the modular jack on the wall.

5.Place the Base Unit on the posts of the wall plate and push down until it’s firmly seated.

6.Plug the AC Adapter into a standard 120V AC wall outlet.

Note: Do not use an outlet controlled by a wall switch.

Direct Wall Mounting

If you do not have a standard wall plate, you can mount your phone directly on a wall. Before mounting your phone, consider the following:

Select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall.

Make sure the wall material is capable of supporting the weight of the Base Unit and Handset.

Use #10 screws with anchoring devices suitable for the wall material where the Base Unit will be placed.

1. Insert two mounting screws 31516 inches apart. Allow about 316 of an inch between the wall and screw heads for mounting the phone.

2. Plug the AC

Adapter into the

Base Unit.

3. Place the AC Adapter cord inside the molded channel.

XCA550/55

11

Image 11
Contents Contents Using a Touch-Tone Phone Important Safety Instructions Battery Safety Precautions ∙ AutoTalk ∙ AutoStandby FeaturesIntroduction ∙ AutoSecureRange Telephone Line ProblemsIncluded with the XCA550/55 Important Electrical ConsiderationsCordless Telephone Privacy Radio InterferenceMore Than One Cordless Telephone Telephone Line Outlets InstallationConnecting the Telephone Cords Selecting a LocationAdapter Safety Feature Applying Power to the Base UnitStandard Wall Plate Mounting Desk or Tabletop InstallationWall Installation TEL Line jack on the Base Unit Direct Wall MountingSetting the Handset Retainer XCA550/55 Extending the Antenna Setting Up Your PhoneInstalling the Handset Battery Pack Battery Memory Effect Cleaning the Battery ContactsCharging the Battery Pack Initial Battery ChargingSetting Handset Ringer Volume Low Battery IndicatorSetting the Pulse/Tone Switch Setting the Handset Listening VolumeAutomatic Digital Code Security Changing Channels, Flash, and Page/Find Using Your PhoneMaking and Receiving Calls LED blinks Programming Your PhoneStoring a Number in Memory Storing a Mixed NumberErasing a Stored Number Dialing a Stored NumberChain Dialing Integrated Answering System Answering System SetupTurning the Answering System On/Off Setting the Clock Hour setting is announcedReviewing Your Time Stamp Setting Your PIN CodeRecording Your Personal OGM Setting Your Outgoing Message OGMSelecting a Preset OGM Preset MessagesPreset message will begin to play on the Base Unit speaker Using the Reset ButtonSetting the Toll Saver Switch VOX/Calling Party Control FeatureSkipping a Message Using Your Answering SystemPlaying New Messages Repeating a Message Playing Old MessagesMessage Full Indication Deleting All MessagesDeleting a Message Two begin flashing in the display Using a Touch-Tone PhoneRemote Operation Leaving a Memo MessageTelephone Troubleshooting Chart TroubleshootingAnswering System Troubleshooting Chart Base Unit SpecificationsXCA550/55 Telephone Answering Device Rechargeable Nickel-Cadmium Battery Warning PrecautionsControls and Functions Handset 7 9 Controls and Functions BaseOne Year Limited Warranty Covered under one or more of the following U.S. patents