Using the Flash Button, Chain Dialling

The flash + 2 call waiting

USING THE FLASH BUTTON

Australia

If you have the “call waiting” service and a call waiting tone sounds while you are on a call, press flash then

procedure toggles between the incoming and original call (and visa versa).

The flash + 1 procedure will drop the current call

2 to accept the waiting call. There is a short pause, then you will hear the new caller. To return to the original caller press flash then 1.

New Zealand

flash

connection and pick up the incoming call on hold.

If you have the “call waiting” service and a call waiting tone sounds while you are on a call, press the flash

button to toggle between the incoming call and the original call (and visa versa).

CHAIN DIALLING

flash

After dialling a number you may be requested to enter a special access code, for example, when performing a banking transaction.

1.Store the access code into one of the memory locations (0-9).

2.Dial the main number.

3.Press mem and the memory location where you stored the access code at the appropriate time.

ERASING A STORED NUMBER

1.Remove the handset from the base.

2.Press mem twice.

3.Press the memory location number (0-9) you want to clear. You hear a long beep confirming that you have erased the number.

REPLACING A STORED NUMBER

Remember your XS610 phone has 10 memory locations, represented by the numbers 0-9 on the keypad. If you store a phone number in one of these locations, then attempt to store a different number in the same location later, the new number will replace the previous one.