Uniden XS610 manual Trouble Shooting

TROUBLESHOOTING YOUR NEW PHONE

TROUBLE SHOOTING

If your XS610 cordless telephone is not performing to your expectations, please try these simple steps first before calling Uniden customer service.

Caution: Do not attempt to service this until yourself. Servicing must be performed by qualified personnel.

PROBLEM		SUGGESTION
	●	Make sure the AC adaptor is plugged into the base and
Charge light won’t		wall outlet.
come on when	●	Make sure the handset is properly seated in base.
handset is placed	●	Make sure the charging contacts on the handset and base
in base.
		are clean.
	●	Make sure that the base antenna is fully extended in the
		vertical position.
The audio sounds	●	Interference by other electronics equipment such as TVs.
weak and/or
		Computers microwaves etc.
scratchy.
	●	You may have gone too far from the base.
	●	Press the chan key to search for clearer reception.
	●	Check both ends of the base telephone
		line cord.
	●	Make sure the AC adaptor is plugged into the base and
Can’t make or		wall outlet.
	●	Disconnect the AC adaptor for a few minutes, then
receive calls.
		reconnect it.
	●	Reset security code by placing the handset back on the
		base for a few seconds. The status LED will blink
		indicating that the phone has been reset.
	●	The Nickel-Cadmium battery pack may be weak.
		Charge the battery for 15-20 hours.
The handset	●	The handset may be too far away from the base.
		Place the base away from appliances or metal objects.
doesn’t ring or
		Place the base away from appliances or metal objects.
receive a page.	●
		Reset security code by placing the handset back on the
	●
		charging cradle for a few seconds. The status LED will
		blink indicating that the phone has been reset.

18