Uniden EXA2955 instruction manual Symptom Remedy

Page 49

Intercom

Answering machine

from an

phone

Operating

outside

Power source/battery

 

Symptom

Remedy

 

The handset does not ring

• The handset may be engaged in conversation.

 

when calling from the base

• The battery may be weak. Charge the battery for 15-20

phone.

hours (page 11).

 

 

• Move the handset closer to the base phone.

 

 

• Place the base phone away from noise sources

 

 

(page 8).

 

Message is not recorded.

• The remaining recording time is less than 30 seconds

 

or 59 messages were recorded. The answering machine

 

becomes “Memory full” status and does not record

 

 

messages. Erase messages (page 40).

 

 

• The message is less than two seconds. The answering

 

machine does not record messages less than two

 

 

seconds in length.

 

 

 

 

No sound from the speaker of

• Adjust the speaker volume (page 40).

 

the base phone.

 

 

 

 

 

The caller’s message is

• The caller’s message is too long.

 

interrupted.

• The caller’s voice is too low. The phone disconnects

 

the line when it detects seven seconds of silence.

 

 

 

 

The clock is incorrect.

• There was a power interruption. Reset the time

 

 

(page 32).

 

The phone does not accept

• Make sure you call from a touch-tone phone.

 

your remote ID code (security

• Make sure the remote ID code (security code) is

 

code).

correct.

 

 

• Make sure you entered the remote ID code (security

 

code) within two seconds after you’ve entered

.

 

 

The line is disconnected when

• You entered wrong remote ID codes (security codes)

you call your phone from a

three times.

 

touch-tone phone.

 

 

The CHARGE LED does not

• Wipe the charge terminals of the base phone and the

light up when you place the

handset with a soft cloth for better contact of the

 

handset to charge.

charge terminals.

 

 

• Make sure the handset is placed on the base phone

 

 

properly.

 

The battery duration is short. • The battery pack was charged for 15-20 hours (due to power failure, etc.).

The usage life of the battery has expired and needs replacement.

continued

Additional Information

Additional Information

49

Image 49
Contents Cordless Telephone Important Safety Instructions PrecautionsImportant Electrical Considerations Additional Battery Safety PrecautionsTelephone Line Outlets Installation ConsiderationsTable of contents About the digital security code Read this firstStep Choose the best location Setting up the base phoneIf you want to hang the base phone on the wall, see Connect the base phoneIf your dialing system is Set the switch to Choose the dialing modeIf you aren’t sure of your dialing system TipPreparing the battery pack To obtain the best performance from the battery Battery durationWhen to purchase a new battery pack Antenna Speaker SET UP button pTalk button p Dialing keys pIdentifying the parts Erase button p VOL Volume +/- buttonSpeaker Phone button DC in 9V jack p Line telephone line jackDo this Additional tasksMaking calls through the speakerphone If the handset battery becomes weak during a callMaking calls RedialingOn the handset On the base phoneReceiving calls through the speakerphone Receiving callsStoring phone numbers on the handset Memory dialingStoring phone numbers on the base phone Telephone FeaturesMaking calls with memory dialing on the base phone Making calls with memory dialing on the handsetMemory dialing To store the previous number dialed To change a stored numberTurning off the ringer Setting the ringer typeTo turn the ringer on again Setting the ringer type Adjusting the ringer volume level of the base phoneChecking the ringer type To switch from the base phone to the handset Switching the phones during a callSwitching the phones during a call To switch from the handset to the base phoneTo talk from the handset to the base phone Talking between the handset and the base phone IntercomTips To talk from the base phone to the handset When you are done talking or if no one answers the phoneTalking between the handset and the base phone Intercom To transfer from the base phone to the handset Transferring a callIf no one answers the phone Transferring a call To transfer from the handset to the base phoneHaving a three-way conference When you are done talkingTo join the phone conversation Answering Machine Features Setting up the answering machineTo hear the current time Recording the greetingTo check the greeting Setting up the answering machineTo change the greeting To erase the greetingPrerecorded greetings Setting the number of ringsSetting the audible message alert Turning on the answering function When a caller callsMailbox usage To turn off the answering functionSetting up the answering machine When the memory is full Playing back messages Additional tasks when playing back messagesErasing messages Adjusting the speaker volumePlaying back messages To erase individual messagesAnswering Machine Features Selecting the Announcement Only Mode To answer the call Screening callsRecording a memo message To change the remote ID code security code Operating from an outside phone Operating from an outside phone Picking up new messages Table of control codes Key34,5 Mounting the base phone on a wallTroubleshooting Symptom Remedy Troubleshooting MaintenanceWhen the counter shows It means Message counterGeneral SpecificationsHandset Answering machineX, Y, Z IndexPage Page Uniden America Corporation One Year Limited Warranty523,058 595,795 797,916 381,460 426,690