Uniden EXS9005 manual Chain Dialing, Erasing a Stored Number

Chain Dialing

On certain occasions, after dialing a number, you may be requested by the party or service you are calling to enter a special access code, such as when performing a banking transaction. To do this, simply:

1.Store the access code into one of the memory numbers.

2.Dial the main number.

3.At the appropriate time, press mem followed by the memory location number where the access code is saved.

Erasing a Stored Number

To erase a number previously stored in a memory location (01-20), follow these steps:

1. Remove the Handset from the Base Unit.

2. Press mem twice.

3. Press the two-digit memory location number (01-20).

Example:

for memory location 02, you would press 0, then 2.

A confirmation tone (double beep) indicates that the number is erased.

If you enter a invalid two-digit memory location, a loud single beep sounds.

❊If more than 30 seconds elapse between each keystroke entry or step, an error tone will sound and the erase procedure will be canceled.

28 EXS9005