Uniden EXI 386 Series manual Changing the Digital Security Code, Installing the Beltclip

Page 40

If the handset battery pack is completely discharged or the battery pack is removed, the digital security code will be lost. If this happens, a new security code is set automatically next time the battery pack is charged.

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is not necessary. The first time you charge your handset, the security code is automatically set. (See "About the digital security code", page 6.) In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code.

1)Remove the handset from the base unit. Press and hold find handset on the base.

2)The handset begins emitting a paging sound. While holding find handset, place the handset on the base unit. The paging sound stops.

Leave the handset on the base for more than 3 seconds. A new random security code is set.

Installing the Beltclip

To attach the beltclip

Insert the beltclip into the holes on each side of the handset. Press down until it clicks.

To remove the beltclip

Pull both sides of the beltclip to release the tabs from the holes.

Headset Installation

Your phone may be used with an optional headset, the Uniden HS910. To use this feature, insert headset plug into the headset jack.

Your phone is ready for hands-free conversations. (You can purchase a headset by calling the Uniden Parts Department or visiting the web site. See Page 7.)

[ 38 ] A D D I T I O N A L I N F O R M A T I O N

Image 40

Contents Page Page Contents Features WelcomeQuick Reference Guide Controls and Functions Status LED Read this First 9 toChecking the Package Contents Choose the best location Setting up the PhoneDo the following steps See Low Battery Alert Cleaning the battery charging contactsConnect the base unit For assistance ModularMounting the Base Unit on a Wall Standard wall plate mountingTerminology Direct wall mountingSetting Menu Options Caller ID optionsChoosing the dialing mode Setting the Language Making and Receiving Calls Handset On Base Handset Off BaseAdjusting the Handset Ringer and Earpiece Volume Handset ringer tone and volumeEarpiece volume Ringer MuteRedial Tone Dialing Switch overTraveling Out-of-Range Selecting a Different Channel HintsFlash and Call Waiting Storing Phone Numbers and Names Memory DialingE M O R Y D I a L I N G If you make a mistake while entering a name Steps for Entering Names and Special CharactersNumber of times key is pressed E M O R Y D I a L I N G Making Calls with Memory Dialing Memory dialing from Standby ModeDisplay a Programmed Number Memory dialing from Talk Mode Chain DialingEditing a Stored Name and/or Phone Number Press and hold mem until ¨Memory Store¨ is displayedUniden Corp John DOE Erasing a Stored Name and Phone Number Storing and Editing the RocketDial RocketDialMaking Calls with the RocketDial Deleting the RocketDial RocketdialYou must subscribe to Caller ID service to use this feature When the Telephone RingsCaller ID Viewing the Caller ID Message List When the pointer is at ¨Yes¨ When the pointer is at ¨No¨Deleting Information from the Caller ID List Deleting a Caller ID messageTone sounds and all stored Caller ID messages are deleted Calling a party from the Caller ID list Using the Caller ID ListDial edit Storing Caller ID messages in Memory dialing Installing the Beltclip Headset InstallationChanging the Digital Security Code To attach the beltclipBattery replacement and handling MaintenancePower Failure Troubleshooting Symptom SuggestionSymptom Suggestion Liquid Damage Case ActionGeneral Information Battery InformationAC Adapter Information Precautions Installation Considerations Terminal Equipment Radio Equipment Index K, LMemo At Uniden, we´ll take care of you