Uniden EXI 386 Series manual Installation Considerations

Page 47

Radio Interference

Radio interference may occasionally cause buzzing and humming in your cordless handset, or clicking noises in the base. This interference is caused by external sources such as TV, refrigerator, vacuum cleaner, flu- orescent lighting, or electrical storm. Your unit is NOT DEFECTIVE. If these noises continue and are too distracting, please check around your home to see what appliances may be causing the problem. In addition, we recommend that the base not be plugged into a circuit that also powers a major appliance because of the potential for interference. Be certain that the antenna on the unit is fully extended when needed.

In the unlikely event that you consistently hear other voices or distract- ing transmissions on your phone, you may be receiving radio signals from another cordless telephone or other source of interference. If you cannot eliminate this type of interference, you need to change to a dif- ferent channel.

Finally, it should be noted that some cordless telephones operate at fre- quencies that may cause interference to nearby TVs and VCRs. To mini- mize or prevent such interference, the base of the cordless telephone should not be placed near or on top of a TV or VCR. If interference is experienced, moving the cordless telephone farther away from the TV or VCR will often reduce or eliminate the interference.

More Than One Cordless Telephone

If you want to use more than one cordless telephone in your home, they must operate on different channels. Press the channel key to select a channel that provides the clearest communication.

Cordless Telephone Privacy

Cordless telephones are radio devices. Communications between the handset and base of your cordless telephone are accomplished by means of radio waves which are broadcast over the open airways. Because of the inherent physical properties of radio waves, your communications can be received by radio receiving devices other than your own cordless telephone unit. Consequently, any communications using your cordless telephone may not be private.

Installation Considerations

Selecting a Location

Before choosing a location for your new phone, there are some impor- tant guidelines you should consider:

The location should be close to both a phone jack and continuous power outlet. (A continuous power outlet is an AC outlet which does not have a switch to interrupt its power.)

Keep the base and handset away from sources of electrical noise such as motors or fluorescent lighting.

Be sure there is sufficient space to fully extend the base antenna.

The base can be placed on a desk or tabletop or mounted on a stan- dard telephone wall plate.

You should charge your new phone for 15-20 hours before complet- ing the installation or using the handset.

Telephone Line Outlets

There are two types of phone outlets:

Modular Jack

Most phone equipment available now uses modular jacks. Phone cords are fitted with a molded plastic connector which plugs into this type of

jack. If you do not have modular phone jacks, contact your local tele- phone company for information about their installation.

Hardwired Jack

Some equipment is wired directly to a phone jack, and these types of installations require a modular jack converter. This type of installation is not difficult; however, you should contact your Uniden telephone dealer or a telephone supply store for advice about the proper adapter or con- verter for your particular situation.

Connecting the Telephone Cords

Consider these safety guidelines before connecting the telephone cords:

Caution!

Never install telephone wiring during a lightning storm.

Never touch uninsulated telephone wires or terminals unless the tele- phone line has been disconnected.

Use caution when installing or modifying telephone lines.

Applying Power to the Base

This phone requires an AC outlet, without a switch to interrupt power, and the included AC adapter. To relieve strain on the DC plug when the phone is placed on a desk or table, wrap the power cord around the strain relief notch on the bottom of the base.

NOTE:

Place the power cord so that it does not create a trip

 

hazard, or where it could become chafed and create a fire

 

or other electrical hazards.

Adapter Safety Features

If the AC adapter furnished with this phone has a polarized line plug (a plug having one blade wider than the other), this plug will fit into the power outlet only one way. If you are unable to insert the plug fully

into the outlet, try reversing the plug.

Do not alter the shape of the blades of the polarized plug!

NOTE: If you cannot plug the AC adapter into the out- let, contact someone about replacing the outlet.

Plug the AC Adapter into a standard 120 VAC wall outlet.

Do not use an outlet controlled by a wall switch.

Use only the Uniden AC Adapter supplied with this phone.

One Year Limited Warranty

Important: Evidence of original purchase is required for warranty ser- vice.

WARRANTOR: UNIDEN AMERICA CORPORATION (“Uniden”)

ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this Uniden Product to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below.

WARRANTY DURATION: This warranty to the original user shall terminate and be of no further effect 12 months after the date of original retail sale. The warranty is invalid if the Product is (A) damaged or not main- tained as reasonable or necessary, (B) modified, altered, or used as part of any conversion kits, subassemblies, or any configurations not sold by

Uniden, (C) improperly installed, (D) serviced or repaired by someone other than an authorized Uniden service center for a defect or malfunc- tion covered by this warranty, (E) used in any conjunction with equip- ment or parts or as part of any system not manufactured by Uniden, or

(F)installed or programmed by anyone other than as detailed by the owner’s manual for this product.

STATEMENT OF REMEDY: In the event that the product does not conform to this warranty at any time while this warranty is in effect, warrantor will either, at its option, repair or replace the defective unit and return it to you without charge for parts, service, or any other cost (except shipping and handling) incurred by warrantor or its representatives in connection with the performance of this warranty. Warrantor, at its option, may replace the unit with a new or refurbished unit. THE LIMIT-

ED WARRANTY SET FORTH ABOVE IS THE SOLE AND ENTIRE WARRANTY PERTAINING TO THE PRODUCT AND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY OPERATION OF LAW, INCLUDING, BUT NOT LIM- ITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THIS WARRANTY DOES NOT COVER OR PRO- VIDE FOR THE REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR CONSE- QUENTIAL DAMAGES. Some states do not allow this exclusion or limita- tion of incidental or consequential damages so the above limitation or exclusion may not apply to you.

LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This warranty is void outside the United States of America.

PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after fol- lowing the instructions in the owner’s manual you are certain that the Product is defective, pack the Product carefully (preferably in its origi- nal packaging). The Product should include all parts and accessories originally packaged with the Product. Include evidence of original pur- chase and a note describing the defect that has caused you to return it. The Product should be shipped freight prepaid, by traceable means, to warrantor at:

Uniden America Corporation

Parts and Service Division

4700 Amon Carter Blvd. Fort Worth, TX 76155 (800) 297-1023, 8 a.m. to 5 p.m. Central, Monday through Friday

A D D I T I O N A L I N F O R M A T I O N

A D D I T I O N A L I N F O R M A T I O N [ 45 ]

Image 47
Contents Page Page Contents Welcome FeaturesQuick Reference Guide Controls and Functions Status LED 9 to Read this FirstChecking the Package Contents Do the following steps Setting up the PhoneChoose the best location See Cleaning the battery charging contacts Low Battery AlertFor assistance Modular Connect the base unitStandard wall plate mounting Mounting the Base Unit on a WallDirect wall mounting TerminologyCaller ID options Setting Menu OptionsChoosing the dialing mode Setting the Language Handset On Base Handset Off Base Making and Receiving CallsRinger Mute Adjusting the Handset Ringer and Earpiece VolumeHandset ringer tone and volume Earpiece volumeTraveling Out-of-Range Tone Dialing Switch overRedial Flash and Call Waiting HintsSelecting a Different Channel Memory Dialing Storing Phone Numbers and NamesE M O R Y D I a L I N G Number of times key is pressed Steps for Entering Names and Special CharactersIf you make a mistake while entering a name E M O R Y D I a L I N G Display a Programmed Number Memory dialing from Standby ModeMaking Calls with Memory Dialing Chain Dialing Memory dialing from Talk ModePress and hold mem until ¨Memory Store¨ is displayed Editing a Stored Name and/or Phone NumberUniden Corp John DOE Erasing a Stored Name and Phone Number Making Calls with the RocketDial RocketDialStoring and Editing the RocketDial Rocketdial Deleting the RocketDialCaller ID When the Telephone RingsYou must subscribe to Caller ID service to use this feature Viewing the Caller ID Message List Deleting a Caller ID message When the pointer is at ¨Yes¨When the pointer is at ¨No¨ Deleting Information from the Caller ID ListTone sounds and all stored Caller ID messages are deleted Dial edit Using the Caller ID ListCalling a party from the Caller ID list Storing Caller ID messages in Memory dialing To attach the beltclip Installing the BeltclipHeadset Installation Changing the Digital Security CodePower Failure MaintenanceBattery replacement and handling Symptom Suggestion TroubleshootingSymptom Suggestion Case Action Liquid DamageAC Adapter Information Battery InformationGeneral Information Precautions Installation Considerations Terminal Equipment Radio Equipment K, L IndexMemo At Uniden, we´ll take care of you