UP354BH(WDECT2355+2) OM 5/14/04 10:51 AM Page 37
CHAIN DIALING
The memory locations in the handset are not limited to phone numbers. You can also store a group of numbers (up to 20 digits), that you need to enter once your call connects. This is referred to as Chain Dialing.
An example of this is a bank account number. Store the account or special number in one of the phonebook locations. (Refer to “Storing Phone Numbers, Names, Distinctive Rings and Speed Dial” on page 30.) When you call your bank and you are prompted to enter the account number, scroll through your phonebook locations
until you find your account number, and then press 
.
MEMORY DIALING (BASE ONLY)
You can store 10 phone numbers in the base, and make calls with memory dialing from the base.
Storing Phone Numbers
1) Press mem in standby mode.
2) Enter the number you wish to store. (The number cannot exceed 20 digits.)
3) Press mem. Enter the memory location number
Making Calls with Memory Dialing
1) | Press | in standby mode. |
2) | Press | mem. Enter the memory location number |
Deleting the Stored Data
1)Press mem in standby mode.
2)Press mem again.
3)Enter the memory location number
•The 10 memory locations in the base are independent from the handset.
•If you have not pressed any key for 30 seconds, the phone returns to standby mode.
[ 37 ]