Panasonic DMR-E75V Manual Dubbing DVD l VHS, About DC channel, Preparation DVD Recording source

Advanced Operations DVD VHS

∫Manual Dubbing (DVD l VHS)

You can specify the position to start dubbing the programme recorded on the disc to the tape.

≥The available discs for dubbing source are discs without copy guard. Most of DVD-Videos are copy-guarded to prevent illegal reproduction and they cannot be recorded with the following procedure.

Preparation

DVD (Recording source)

≥Insert the disc containing the programme to be copied. (l 17)

VHS (Recording target)

≥Insert a video cassette with an intact erasure prevention tab. (l 50)

≥Confirm that the remaining tape time is sufficient for recording. (l 57)

Settings (“TV System” l 45)

≥When dubbing an NTSC disc to a tape

-Set “TV System” on “Connection” in “SETUP” to “NTSC”. ≥When dubbing a PAL disc to a tape

-Set “TV System” on “Connection” in “SETUP” to “PAL”.

[1]Press [DVD] and press [1, PLAY].

[2]Press [AUDIO] to Select the audio to be played

(the audio to be recorded) beforehand. [RAM]

≥When the DVD-R is inserted, you cannot select the audio.

[3]Press [;, PAUSE] at the start point of the recording.

[4]Press [VHS].

[5]Select “DC” channel with [CH, W, X].

≥The picture of the DVD is displayed on the TV.

≥When the “TP” channel is selected on DVD, you cannot select the “DC” channel.

[6]Press [1, PLAY].

Start playing the video cassette and find the recording start point.

[7]Press [;, PAUSE] at the start point of the

recording, then press [¥, VHS REC] to pause.

Put the unit in the recording standby mode.

[8]Press [REC MODE] to select the recording mode.

[9]Press [;, PAUSE].

≥VHS recording and disc play start at the same time.

To pause or stop Manual Dubbing

You cannot stop or pause on DVD and VHS at the same time

∫To pause or stop recording

Press [VHS] and press [;, PAUSE] or [∫, STOP].

∫To pause or stop play

Press [DVD] and press [;, PAUSE] or [∫, STOP].

∫When dubbing is started, the following operations also

start automatically

≥“On-Screen Messages” on Display ) “Off” (l 45)

Note

≥When “DVD / VHS Output” is set to “Manual” (l 43), or when DVD output is selected in starting dubbing, the output is switched to VHS automatically at the time when dubbing is started.

≥Switching the audio mode by pressing [AUDIO]. The audio which you are hearing is recorded.

∫About DC channel

(DC: Dubbing input channel)

When you select DC channel, VHS can receive the video/audio signal from DVD. This enables you to dub the video played back on DVD to VHS.

≥Press [VHS] and press [CH, W, X] several times to select DC channel.

≥Contrary to DC channel, TP channel is the channel for DVD to receive the video/audio signal from VHS. (l 59)

≥When the “TP” channel is selected on DVD, you cannot select the “DC” channel.

61