Panasonic DMR-E75V Error messages, Common, Operation, On the TV, On the unit’s display

Helpful Hints DVD VHS

Error messages

∫Common

Operation

X HOLD

	Page
≥The Child Lock function is activated.
Press and hold [ENTER] and [RETURN] simultaneously until “X HOLD”	62
disappears.

∫ DVD

On the TV		Page
Cannot finish recording completely.	≥The programme was copy-guarded.	–
	≥The disc may be full.
Cannot record on the disc.
Please check the disc.	≥The disc may be dirty or scratched.	17
Unable to format.
Cannot record. Disc is full.	≥Create space by erasing any unnecessary titles. [RAM]	29, 31
	≥Use a new disc. [RAM] [DVD-R]	–
Cannot record. Maximum number of titles
recorded.
Error has occurred. Please press ENTER.	≥Press [ENTER] to start recovery process. You cannot operate the unit while it is
Timer Recording standby or Ext Link	recovering (“SLF CHECK” appears on the unit’s display).	–
standby will be canceled.
No Disc	≥The disc is upside down.	17
Please change the disc.	≥There may be a problem with the disc. Press [< OPEN/CLOSE] on the main unit
	to remove it and check it for scratches or dirt. (The unit turns off automatically	17
	after you open the tray.)
This is a non-recordable disc. Cannot record.	≥The unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized	–
	DVD-R.
This disc is not properly formatted.
Formatting is necessary using DISC	≥You inserted an unformatted DVD-RAM. Format the disc with this unit.	29
MANAGEMENT.
	≥The operation is prohibited by the unit or disc.	–

On the unit’s display				Page
HARD ERR	≥If there is no change after turning the unit on and off, consult the dealer where the			–
		unit was purchased.
NO READ	≥The disc is dirty or badly scratched. The unit cannot record, play, or edit.			17
	≥You have used a DVD-RAM/PD lens cleaner and it has finished.			–
		Press [< OPEN/CLOSE] on the main unit to eject the disc.
PROG FULL	≥There are already 16 timer programmes. Erase unnecessary timer programmes.			27, 55
REMOTE MODE ∑	≥The remote control and main unit are using different codes. Change the code on
(“∑” stands for a number.)		the remote control.
			Press and hold [ENTER] and the	11
			indicated number button at the same
			time for more than 2 seconds.
SLF CHECK	≥The unit is starting up. Wait until the message disappears.			–
U59	≥The unit is hot.
		The unit switches to standby for safety reasons. Wait for about 30 minutes until
		the message disappears.		–
		Select a position with good ventilation when installing the unit. Do not block the
		cooling fan on the rear of the unit.
U99	≥The unit fails to operate properly. Press [Í/I] on the main unit to switch the unit to			–
		standby. Now press [Í/I] again to turn the unit on.
UNSUPPORT	≥You have inserted a disc the unit cannot play or record on.			15

66