Panasonic SL-SX240, SL-SX280 Sequential Play, Hold Function, Follow steps Resume function

Sequential Play

Basic Play

4 Track number in play	5	VOL		VOL
			C	S-XBSTRAIN	1
		VOL		ALL1 M
		Increase		RANDOM
			SORRY			OPEN

VOL

C S-XBSTRAIN

ALL1 M

RANDOM

SORRY

Elapsed playing time
of each track	O
	P
	R
	O
	F
	F

3	HOLD	Plug type:
		3.5 mm stereo

Decrease

		Label must face upward.
	2 R	Close the lid.
SL-SX280		L

Follow steps 1–5.						Resume function
In step 2: Connect the stereo earphones and the wired remote control to the headphone jack [Ë]. (Plug in firmly.)						The player stores the track where you stopped play and
In step 5: The volume range is 0-25. (Press and hold to change the volume successively.) The volume changes						if you press [1 ;] (main unit) or [∫/1] (remote control)
		when pressed while the level is displayed. If any other display is shown, it changes to show the current				play resumes from the beginning of the track.
		level. (The volume returns to 10 when you disconnect the power source.)				The resume function is canceled (play starts from the
≥Play stops automatically when all the tracks have been played.						first track) if you open the lid when the unit is in stop
≥If the unit has been connected to the car audio system, set this unit’s volume to 10, then adjust the volume level on the system.						mode. It is also usually canceled when you replace the
						CD while the unit is off.
	Operation		Button		Display/reference	Note!
						≥The resume function may work if you replace the CD
			Press during play.			while the unit is off.
					VOL	≥If you turned the unit off near the end of the track, play
	To pause play				C S-XBSTRAIN	may resume from the beginning of the next track.
					ALL1 M	≥The resume function works automatically and cannot
					Press again to restart play.	be turned off.
			Press during play.		Total number of tracks	Removing discs
	To stop play				VOL	1 Press [∫,OPR OFF] to stop play and disc rota-
						tion.
	Stop mode		O
			P		C S-XBSTRAIN	2 Slide [OPEN 1] to open the lid.
			R
			O
			F		ALL1 M	3 Press [PUSH] to release the disc.
				F	Total playing time
						Do not stop the disc by hand or try to remove it before it
			Press during stop
						stops rotating. This can damage CDs.
			mode.
	To turn off the
					VOL
	unit	Off mode
			O
			P
			R		C S-XBSTRAIN
			O
			FF		ALL1 M
						HSUP
			Press during play.		≥During program play (page 4), these buttons are	PUSH
	Skipping		(Press [:] twice to skip to the
			beginning of the previous tracks.)		used to skip forward or back through the pro-
		tracks			grammed sequence of tracks.
						Note1
			Backward	Forward	≥You cannot skip to tracks that have been played
					in random or random repeat play (page 4).	Never insert foreign objects into the unit body.
	Searching				≥During program play, 1-track repeat play, random	Auto power off function
					play and random repeat play (page 4), search op-	If you leave the unit in stop mode for about 10 minutes
	through tracks		Press and hold during play.		eration is limited to the current track only.	(30 seconds if disc isn't loaded), it turns off to save the
						batteries.
For your reference:						Note on CD-R and CD-RW
“		” indication				This unit can play CD-DA format audio CD-R and
This indication appears for about 30 seconds if [1;] (main unit) or [∫/1] (remote control SL-SX280) is pressed						CD-RW that have been finalized§ upon completion
when no disc is loaded in the unit or if the disc is not properly secured.						of recording. It may not be able to play some CD-R
“*” indication						or CD-RW due to the condition of the recording.
This indication appears for about 10 minutes when the lid is opened. (However, the indication does not appear when						§Finalizing is a process that enables CD-R/CD-RW players
the unit is powered off.)						to play audio CD-R and CD-RW.

3

HOLD Function

SL-SX280

HOLD

HOLD

HOLD mode

This function causes the unit to ignore short, accidental button presses. (The disc lid can still be opened and closed.)

The HOLD function prevents the following:

≥The unit is powered on accidentally when not in use, causing the batteries to run down.

≥A button is accidentally pressed during play, interrupt- ing the operation.

SL-SX280

The unit and wired remote control have HOLD func- tions, each of which works independently.

To use the HOLD function

Set [HOLD] to the HOLD position.

“(” indication

When the unit is in HOLD mode, pressing any button causes the indication “(” to appear on the display.

When the unit is powered off

The “(” indication appears only when [1;] (main unit) is pressed.

Before operating the buttons

Be sure to move [HOLD] to release the unit from the HOLD mode.