Using the Wired Remote Control
SL-SX280
The remote control can be operated regardless of the hold mode of the unit.
Preparation:
How to use the wired remote control
Release the remote control from the HOLD mode.
HOLD
∫Operation confirmation tones
When an operation button is pressed, a confirmation tone sounds. Refer to the parentheses in the illustration for the different types of confirmation tones.
Press once during off or stop mode.
To start play
(Beep)
Press once during play.
To stop play
(Beep...Beep)
Press and hold during play or stop mode.
To turn off the
unit
(Beep...Bee...p)
| Press once during play. | ||
| (Press [:] twice to skip to the be- | ||
Skipping | ginning of the previous tracks.) | ||
tracks |
|
| Backward |
|
| (Beep Beep | |
|
|
| |
|
|
| Beep) |
Searching |
|
| Forward |
through tracks |
|
| (Beep Beep) |
|
|
| |
| Press and hold during play. | ||
| ≥The volume range is | ||
| and hold to change the volume suc- | ||
| cessively.) |
|
|
| ≥A tone | ||
| you reach the minimum or maximum | ||
To adjust the | volume. |
|
|
volume |
|
|
|
| Decrease | VOL | Increase |
| (Beep) | (Beep) | |
|
| ||
Using the Unit with Optional Accessories |
| Maintenance |
Using the unit with an audio system | Using the unit with a car audio | ||
|
| system | |
Using a stereo phono cable (not included), you can lis- | |||
| |||
| |||
ten to CDs on your audio system. | Items to be purchased | ||
≥Turn off this unit and the other equipment before con- | For connection to the car audio system: | ||
Car stereo cassette adaptor | |||
nection. | Connect the car stereo cassette adaptor to the | ||
≥Do not connect the cable to the PHONO jacks on the | |||
unit’s headphone jack. | |||
amplifier. | |||
(When doing this, set this unit's volume to 10.) | |||
≥Obtain the optional connecting cable if the other | |||
| |||
equipment comes with | For securing the unit and connecting the power | ||
≥Set the unit’s volume to 10, then adjust the volume | supply: | ||
level on the other equipment. | ≥Car adaptor | ||
If the surfaces are dirty
To clean this unit, wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a
≥Never use alcohol, paint thinner or benzine to clean this unit.
≥Before using chemically treated cloth, read the instruc- tions that came with the cloth carefully.
Maintaining the lens
Open the lid and clean the lens as shown in the figure. Use a cotton swab to gently wipe off any
≥You can connect speakers, active or otherwise, with an impedance of 1 k≠ or less to the headphone jack.
Headphone jack (Ë)
Bracket
Screwdriver
Note1
1Remove the screw from the bracket at the rear of the car mounting base.
2Replace the screw in the lower hole of the bracket.
Lens
Air blower for camera lens
Lens
Other equipment
(White) L To CD or AUX 
terminals
(Red) R
Stereo phono cable (not included)
≥When you switch off the car, volume and sound quality may return to the original settings and the resume function may work even if you change the disc.
≥It may not be possible to use the unit with some types of car stereos owing to restrictions imposed by the construction of the car stereo cassette adaptor.
For further details, refer to the instructions of the part concerned.
5