Operating your clock radio

1. Press the On / Standby button to switch on your clock radio.
When ﬁrst switched on, the radio will be in DAB mode. After each use
the radio will remember the mode used and then switch on in that
mode the next time that it is used.	1
	1

2. If the clock radio has been used before, the last used station will be selected.

3.If this is the ﬁrst time that the clock radio has been used a quick scan of the Band III DAB channels will be carried out. During the scanning process the display will show the progress of the station search. The number on the right of the display is the number of stations that have been found.

4.When the scan is completed the ﬁrst station (in numeric-alpha order 0...9, A...Z will be selected. The ﬁrst station in the list of stations found during scanning will be played. The display will show the station name.

5.If no signals are found then 'OFF AIR' will be displayed and it may be necessary to relocate your clock radio to a position giving better reception. You should then carry out a scan to ﬁnd stations as described on page 9.

•Your clock radio has an indicator on the display to indicate the strength of the DAB radio signal being received.

Note: When ﬁrst switched on, the radio will set the volume to a moderately high level, in case the broadcast is very quiet.After you have set the volume using the Volume Up or Down buttons, the radio will remember the setting that you have applied for the next time that it is used.