Operating your clock radio
1.Press the On / Standby button to switch on your clock radio. The display will show "TUNING" for a few seconds.
When first switched on, the radio will be in DAB mode. After each use |
|
the radio will remember the mode used and then switch on in that |
|
mode the next time that it is used | 1 |
2.If the clock radio has been used before, the last used station will be selected.
3.If this is the first time that the radio has been used, then the first station in the list of stations found during scanning will be played. The display will show the station name on the display.
4.If no signals are found then "OFF AIR" will be displayed and it may be necessary to relocate your clock radio to a position giving better reception. You should then carry out a scan to find stations as described on page 11.
•Your clock radio has a indicator 
on the display to indicate the strength of the DAB radio signal being received.
Note: When first switched on, the radio will set the volume to a moderately high level, in case the broadcast is very quiet.After you have set the volume using the Volume Up or Down buttons, the radio will remember the setting that you have applied for the next time that it is used.
7