Roberts Radio CR9987 manual Automatic Plug and Play setup

Page 9

Automatic Plug and Play setup

When your Clock Radio is first connected to the mains supply, or after a power failure (when backup battery is not installed), the Auto setup will proceed as follows:-

•Your radio will show "FM 87.5", then automatically search all wavebands and store stations in presets.

•Automatically set the time and day of week.

1.Connect to mains (see page 6). Your radio will scan through the FM waveband, storing stations of sufficient strength as presets.

Note: To interrupt the automatic tuning, press the Prog/Random button once.

2.Your radio is ready for use when the FM waveband has been fully searched.

After having performed the automatic memory set up process, the display will show a DEMO briefly introducing the RDS features.

3. The Clock Time (CT) indicator will flash in the display whilst time

5

setting is carried out.

 

Note: To interrupt the automatic time set, or stop the DEMO mode, press

5

any button once.

4.If the first station detected by the automatic setup does not carry CT information your radio will automatically change to another

station after 1-2 minutes. This process will repeat until the clock is

5

set.

5.Press the BAND button to switch on your radio and press the up and down buttons to select a preset station. Adjust the volume using the VOLUME control. To switch off your radio press the StandBy button.

Note:- Auto setup can take up to 5 minutes to complete and is dependent on the signal strength and number of stations in your area.

Should Auto setup fail, setting the clock and pre-setting stations can be5 carried out manually as described in the following sections.

If you need any further advice, please call our Technical Helpline on :-

020 8758 0338 (Mon-Fri)

8

 

Page 8 Page 10
Image 9
Page 8 Page 10
Contents CR9987 Contents Controls Top Controls Left Side Right Side Controls Front Remote Control Controls Display Battery operation Important Information please read before useMains Operation Night light Display backlightAutomatic Plug and Play setup Setting the Clock Automatically Ensure that the radio is switched off press StandBy Setting the clock/day of week manuallySetting the alarms to wake to buzzer Setting the alarm timesSetting the alarms to wake to radio Setting the alarms to wake to CD Weekend alarm cancel Displaying the alarm time and alarm modeSnooze control Sleep timerOperating your radio search tuning Select the required waveband by pressing the Band button. Operating your radio manual tuningFlash in the display Pre-setting stationsLast station memory Recalling a preset stationClock Time CT automatic adjustment Programme Service PS nameRadio Data System RDS Programme Identification PI Enhanced Other Network EONDisplay Modes Operating your radio using RDS Radio data systemTraffic Announcements TA CD-R/CD-RWdiscs Compact discsInserting a CD Playing a CD Search function Selecting a trackCD repeat mode CD Intro playCD random play Prog/Random button Programmed playChecking and Editing a programme Erasing a programme Remote Control HeadphonesGeneral Back-up Battery not necessary for the unit to functionMains supply FusePower Requirements Specifications Circuit FeaturesPage Guarantee Roberts Radio Technical Services
Top Page Image Contents