Sharp IM-DR400E operation manual Precautions, Storing the unit

Page 9

Precautions

IM-DR400E

!Important

"Do not wear your earphones when you are crossing streets or near traffic.

"Do not use your earphones whilst driv-

ing a motor vehicle, it may create a traf- fic hazard and may be illegal. Remember to obey all of the safety rules in your area.

" Do not play the unit at a high volume. Hearing experts advise against extend- ed listening at high volume levels.

"If you experience ringing in your ears, reduce the vol- ume or discontinue use.

"No naked flame sources, such as lighted candles, should be placed on the apparatus.

"Attention should be drawn to the environmental as- pects of battery disposal.

"The apparatus is designed for use in moderate climate.

"This portable MD should only be used within the range of 0°C - 40°C (32°F - 104°F).

To avoid accidental electric shock or other possible problems, observe the precautions listed below.

"Do not disassemble or modify the unit.

"Do not drop or subject the unit to shock.

"Do not use the unit near open flames.

"Do not spill liquid on the unit.

"Do not use an external power supply, other than the 3 V DC supplied with this unit, as it may damage the unit.

"SHARP is not responsible for damage due to improper use. Refer all servicing to a SHARP authorised serv- ice centre.

!Storing the unit

Avoid using or leaving the unit in the following places.

"Places exposed to direct sunlight for many hours (especially in cars with the doors and windows closed) or near heaters. (The cabinet may deform, change colour or the unit may malfunction.)

"Places exposed to excessive dust.

"Places exposed to water.

"Places where temperatures are excessively high or low.

"Places (bathrooms) where the humidity is extremely high.

"Places with strong magnetic fields such as TVs or loudspeakers.

"Places exposed to vibration.

"Places where sand can easily enter the inside of the unit (beaches etc.).

"If the unit is used near radio tuners or TVs, noise and/ or picture interference may result. If you experience these problems, move the unit away from such devices.

It is not recommended to put the portable MD into a rear pocket, as this may damage the product when sitting.

Using this unit near mobile phones may cause noise pickup. If it oc- curs, move it away from them.

Important Introduction

-Precautions-

 

 

9

1

6

5

4

3

2

1

IM-DR400E TINSE0562AWZZ

03/7/21 IM-DR400E_1.fm

Page 8 Page 10
Image 9
Page 8 Page 10
Contents IM-DR400E Special Notes Special NotesImportant Introduction Features FeaturesPortable MD player with Mobile 1-bit Digital amplifier Pole plug earphone optimizes Mobile 1-bit digital amplifierContents Accessories AccessoriesEarphones x CD-ROM xNames of Controls and Indicators Important Introduction -Names of Controls and IndicatorsMain unit TOC Indicator Track Number Indicator Display panelReference Precautions PrecautionsAvoid using or leaving the unit in the following places Storing the unitPower Source -Using with the AC Adaptor/Alkaline Battery Close the battery coverDo not use a nickel-cadmium battery Inserting a MiniDisc MiniDiscClose the compartment door Connections IM-DR400EConnectionsCheck before connecting To cancel the hold mode IM-DR400EHold FunctionPreparation -Hold Function Before Recording Helpful tip when attaching a labelAbout the TOC Before RecordingRecording Basic Operation -RecordingBefore recording Press the MENU/ENTER button To interrupt recordingTo stop recording Playback To turn off the powerPlayback To interrupt playbackBass control Volume controlTo customise low and high levels Basic Operation -PlaybackAdvanced Playback Useful Features -Advanced PlaybackTo locate the desired portion To locate the beginning of a trackRandom Random play or repeat playAdvanced Recording Useful Features -Advanced RecordingLong-play recording Start recordingIndication Recording mode About the recording modeAbout Atrac LP4Playback sound-actuated recording Lect REC Mode12Begin playback on the stereo system To interrupt recordingTo create your own track numbers Recording tracks as a single trackNumbering restriction About track numbers RecordingAbout sampling rate converter Useful -AdvancedUseful Features -Changing Default Settings Changing Default SettingsTo check the elapsed time and remain- ing time of the track IM-DR400EChecking DisplaysUseful Features -Checking Displays To display the playing time of an indi- vidual trackChecking the remaining amount of bat Tery level Titling a MiniDisc Titling a MiniDiscCreating disc and track names Enter buttonCharacters symbols To erase a characterTo enter a space What is a MiniDisc for stamping? What is a master MiniDisc?To add characters Stamping titles from another MiniDiscTER button Master MiniDisc operation 1 Insert a master MiniDiscEditing a Recorded MiniDisc Editing a Recorded MiniDiscTo erase one track at a time To erase all of the tracks at onceTo combine tracks To divide a trackStart playing the track to be divided into two Combined, and press the buttonPlay the track to be moved, and press To move a trackListening through Another System Resuming auto playAnother What is a Net MD portable recorder? About Net MDNet MD -About Net MD Restrictions on audio data Restrictions on check-in and check-outNet MD -System Requirements System RequirementsHard disk space MB or moreInstallation of BeatJam Software InstallationNet MD -Software Installation Click BeatJam SetupNet MD -Connecting to a PC IM-DR400EConnecting to a PCChecking the USB driver Connecting to aUniversal Serial Bus controllers WindowsTransferring Data Checking outNet MD -Transferring Data MiniDisc System Limitations MiniDisc System LimitationsError Messages Error MessagesTr. Protect Error Meaning Messages No SignalTroubleshooting TroubleshootingCleaning MaintenanceTroubleshooting/Maintenance If trouble occursSpecifications SpecificationsBattery life Input sensitivityOutput level Sharp Corporation
Top Page Image Contents