Packard Bell 100 manual HDD connector

Page 9

8

Fig. 5 The HDD connector.

5.Push the side panel of the top cover gently aside.

6.The mainboard is loose now but the LCD panel is glued to the front. When removing the mainboard, the LCD screen itself will hinge. Carefully tear it loose.

7.When re-inserting the mainboard, avoid pressure on the mainboard area where the LCD is mounted.

8.When putting back the LCD only press the edges of the screen to re-glue it to the front panel.

Note The plastic LCD bracket should be properly clicked into the mainboard before inserting it into the top cover (else there will be too much pressure on the LCD panel when fixing it inside the casing. (see Fig. 6)

Fig. 6 The LCD plastic bracket

Packard Bell Vibe 100 Disassembly Manual

Image 9
Contents Packard Bell Vibe Disassembly Manual Table of Contents Reassembly Instructions Disassembly InstructionsOverview Technician NotesPower Supply Unit Hazardous VoltageAvoid Electrostatic Discharge Waarschuwing Opening the Casing Removing the BatteryRemoving the Hard Disk Location of the battery connectorFlat cable connector Removing the Mainboard/LCD assemblyHDD connector Hold switch Vibe 100 Disassembly Manual