Packard Bell 100 manual Hazardous Voltage, Avoid Electrostatic Discharge, Power Supply Unit

Page 4

3

Hazardous Voltage

There is hazardous voltage present inside the MP3 player when it is connected to an AC supply, even when the MP3 player’s power switch is off. Exposure to hazardous voltage could cause personal injury. To avoid risk of injury, contact an Authorized Service Provider for proper (un)installation of optional hardware devices.

Avoid Electrostatic Discharge

Electrostatic electricity can easily damage circuit cards and integrated circuits (ICs). To reduce risk of damage, store them in protective packaging whenever they are not installed in your system.

Add-in cards can be extremely sensitive to ESD and always require careful handling. After removing the card from the MP3 player, place the card flat on a grounded, static-free surface, component-side up. Use a conductive foam pad if available, but not the card wrapper. Do not slide the card over any surface.

Before you install or remove memory modules, video memory, disk drives, circuit cards or other devices, protect them from static electricity. To do so, make sure your MP3 player’s power switch is OFF. Then, unplug the MP3 player’s AC power cord. Before picking up the device you (un)install, you should wear an anti-static wrist wrap (available at electronic supply stores). Be sure to connect the wrist wrap to an unpainted metal portion of the MP3 player chassis. As an alternative, you can dissipate electrostatic build-up by touching an unpainted metal portion of the MP3 player chassis with one hand. Then touch the device you are (un)installing with the other hand, and maintain continuous contact with it until it is (un)installed in the MP3 player.

Power Supply Unit

Under no circumstances should you attempt to disassemble the power supply. The power supply contains no user-serviceable parts. Inside the power supply are hazardous voltages that can cause serious personal injury. Always return a defective power supply to your dealer.

WARNING

Ensure that the MP3 player is disconnected from its power source and from all telecommunications links, networks, or modem lines whenever the cover is removed. Do not operate the MP3 player with the cover removed.

AVERTISSEMENT Assurez-vous que le lecteur MP3 est débranché de son alimentation ainsi que de toutes les liaisons de télécommunication, des réseaux, et des lignes de modem avant d’enlever le capot. Ne pas utiliser le lecteur MP3 quand le capot est enlevé.

WARNUNG

Der Player darf weder an eine Stromquelle angeschlossen sein noch eine Verbindung mit einer Telekommunikationseinrichtung, einem Netzwerk oder einer Modem- Leitung haben, wenn die Gehäuseabdeckung entfernt wird. Nehmen Sie den Player nicht ohne die Abdeckung in Betrieb.

ADVERTENCIA

Asegúrese de que cada vez que se quite la cubierta del lector MP3, el dispositivo haya sido desconectado de la red de alimentación y de todos lo enlaces de telecomunicaciones, de red y de líneas de módem. No ponga en funcionamiento el lector

Packard Bell Vibe 100 Disassembly Manual

Image 4
Contents Packard Bell Vibe Disassembly Manual Table of Contents Disassembly Instructions Reassembly InstructionsOverview Technician NotesHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge Waarschuwing Removing the Battery Opening the CasingLocation of the battery connector Removing the Hard DiskRemoving the Mainboard/LCD assembly Flat cable connectorHDD connector Hold switch Vibe 100 Disassembly Manual