Packard Bell 100 Overview, Technician Notes, Disassembly Instructions, Reassembly Instructions

Page 3

2

Overview

This document contains step-by-step disassembly instructions for the Vibe 100 MP3 player. The instructions are illustrated where necessary with images of the part that is being removed or disassembled. Furthermore, the screws that are removed are shown next to the image of the parts themselves.

Packard Bell reserves the right to make changes to the Vibe 100 MP3 player without notice.

Technician Notes

Only technicians authorized by Packard Bell should attempt to repair this equipment. All troubleshooting and repair procedures are detailed to allow only subassembly/module level repair. Because of the complexity of the individual boards and subassemblies, no one should attempt to make repairs at the component level or to make modifications to any printed wiring board. Improper repairs can create a safety hazard. Any indication of component replacement or printed wiring board modifications may void any warranty or exchange allowances.

Disassembly Instructions

When disassembling the system unit, follow these general rules:

nTurn off the power and disconnect all cables and peripherals.

nLabel all removed connectors. Note where the connector goes and in what position it was installed.

nDo not disassemble the system into parts that are smaller than those specified in the instructions.

Reassembly Instructions

Reassembly is the reverse of the disassembly process. Use care to ensure that all cables and screws are returned to their proper positions. Check that no tools or any loose parts have been left inside the player. Check that everything is properly installed and tightened.

Required Tools

All disassembly procedures can be performed using the following tools:

nPhilips (#1 bit) screwdriver.

nSmall flat-bladed screwdriver or a small coin.

Packard Bell Vibe 100 Disassembly Manual

Image 3
Contents Packard Bell Vibe Disassembly Manual Table of Contents Technician Notes Disassembly InstructionsReassembly Instructions OverviewPower Supply Unit Hazardous VoltageAvoid Electrostatic Discharge Waarschuwing Opening the Casing Removing the BatteryRemoving the Hard Disk Location of the battery connectorFlat cable connector Removing the Mainboard/LCD assemblyHDD connector Hold switch Vibe 100 Disassembly Manual