Packard Bell 100 manual Removing the Mainboard/LCD assembly, Flat cable connector

Page 8

7

2.Disconnect the flat cable from the hard disk. To do so, lift up the dark-coloured clip and pull out the flat cable.

Fig. 4 The flat cable connector

3.Remove the rubber placeholders, and place them on the new hard disk.

4.Reconnect the flat cable: push in the cable, and push down the clip to secure the cable.

Removing the Mainboard/LCD assembly

To remove the mainboard, open the player (see Opening the Casing), remove the battery (see Removing the Battery) and perform the following steps:

1.Lift up the mainboard to reach the HDD flat cable connector.

2.Lift up the tape covering the HDD connector.

3.Now push down the two clips on the side of the connector.

4.Take out the flat cable.

Packard Bell Vibe 100 Disassembly Manual

Image 8
Contents Packard Bell Vibe Disassembly Manual Table of Contents Disassembly Instructions Reassembly InstructionsOverview Technician NotesAvoid Electrostatic Discharge Power Supply UnitHazardous Voltage Waarschuwing Removing the Battery Opening the CasingLocation of the battery connector Removing the Hard DiskRemoving the Mainboard/LCD assembly Flat cable connectorHDD connector Hold switch Vibe 100 Disassembly Manual