Panasonic EP1060 manual Adjusting Manual Massage Settings, Auto Stop in Manual Operation

Page 17
4. Adjusting Manual Massage Settings

E.g.2 Changing to a massage type outside the category. (Changing to Tap B when Knead is selected.)

• When Knead is combined with Tap B, deselecting Knead will leave only Tap.

manual operation

shiatsu

swedish

knead

vibration

tap A

tap B

whole back

 

regional

roll

Press

manual operation

shiatsu swedish knead

Press

vibration

tap A

tap B

whole back

 

regional

roll

manual operation

shiatsu swedish knead

vibration

tap A

tap B

whole back

 

regional

roll

4. Adjusting Manual Massage Settings

Adjusting the Vertical Position of the Massage Heads

The massage heads will move a little each time the button is pressed. If you hold down the button, the massage heads will continue to move until you release the button. When the massage heads reach their limit you will hear a “peep, peep, peep” sound.

Raising the massage heads

Lowering the massage heads

position

position

Press

 

 

Press

Adjusting the Width between Massage Heads

Vibration, Tap, Shiatsu Whole Back Roll, and Regional Roll can be adjusted in 5-stages while Swedish (gentle) can be adjusted in 3-stages.

As Swedish covers the entire width of the back, it is not possible to adjust width settings.

The massage heads will move a little each time the button is pressed. If you hold down the button, the massage heads will continue to move until you release the button.

When the massage heads reach their limit you will hear a “peep, peep, peep” sound.

Increasing the width

Decreasing the width

position

position

Press

Press

Adjusting Massage Intensity

Massage intensity can be adjusted up to 3 levels.

When the massage heads reach their limit you will hear a “peep, peep, peep” sound.

As Roll or combining Roll with other massages sometimes produce an especially strong massage, adjustment is limited to medium or weak.

Increasing massage intensity

intensity

Press

Decreasing massage intensity

intensity

Press

Roll, Roll + (Shiatsu, Tap B, Tap A, Vibration) Combination

..................................Weak/Medium only

Roll + (Knead, Swedish Combination)

Weak only

For Tap B, Swedish, and Vibration, unless the massage heads are actually touching the body then you may not feel the movement.

5.Auto Stop in Manual Operation

A timer will automatically stop the unit approximately 15 minutes (15–17 minutes) after the massage started. (This is to prevent overuse in the interests of safety.)

The massage heads will move to the retracted position and stop.

The ON/OFF lamp will flash until the heads have stopped moving.

If you want to start another massage, please press Adjusting the Vertical Position of the Massage Heads button.

Please rest at least 10 minutes between massages.

6.Stopping Manual Operation

Press Adjusting the Width between Massage Heads button to stop manual operation.

• The ON/OFF lamp will continue to flash until the massage heads have returned to the retracted position.

17

Image 17
Contents InstruccionesModeloNo. de uso Sillón de masajeEP1061/EP1060 EP1061/EP1060 English INDEX / íNDICEEspañol See pageSAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONSWARNING To avoid the risk of injury, follow these precautions SAFETY PRECAUTIONSCARING FOR THE MASSAGER OPERATING PRECAUTIONSWARNING To avoid damaging to the chair, follow these precautions GROUNDING INSTRUCTIONS HOW TO MOVE THE CHAIRDANGER Use the casters to move the chairEP1061 PART NAMES AND FUNCTIONSEP1060 SEATtheunitUsed.legtovibrationtu on/offmassageandadjust CONTROLLER EP1061AdjustmentButtons ShoulderPositionIndicatorWHERE TO USE THE UNIT SETTING UP THE MASSAGE LOUNGEREnsure there is Adequate Space for Reclining Places to Avoid4. Adjust the Angle of the Backrest and Legrest See Page 1. After Carrying Out Safety Checks, Turn the Unit On See Page5. Turn the Power Off to Finish the Massage See Page z Plug the power plug into the power socketAFTER CHECKING THE SURROUNDING AREA, TURN ON THE POWER BEFORE USING THE UNIT3. Turn the Power On z Plug the power plug into the power socketADJUSTING THE PILLOW ADJUSTING THE SEATSit Down Only When the Legrest is Lowered BEFORE SITTING DOWN1. Reclining The Seat RECLINING THE SEAT2. Retracting The Seat ApproxPROGRAMMED OPERATION 3. Adjusting Shoulder Position1. Press button 2. Select the Program You Want4. Selecting an Area for Concentrated Massage 6. Adjusting Massage Intensity5. Removing Vibration and Tapping from Programs 7. Auto Stop in Programmed OperationMANUAL OPERATION FOR THE UPPER BODY 1. Press button MANUAL OPERATION2. Open the Cover of the Controller 3. Selecting the Massage Type RequiredAdjusting the Vertical Position of the Massage Heads 4. Adjusting Manual Massage SettingsAdjusting the Width between Massage Heads Adjusting Massage Intensity3. Adjusting Massage Intensity 3. Adjusting Massage SpeedLEG MASSAGE IN MANUAL OPERATION EP1061 2. Press the Leg Massage buttonRETURN THE SEAT TO THE ORIGINAL POSITION AFTER COMPLETING THE MASSAGE1. Check that there is Nothing Under the Backrest or the Legrest 2. Return the Seat to the Upright Position2. Unplug the Power Cord DISCONNECT THE POWER 1. Turn Off the PowerGENTLE DETAILS REGARDING PROGRAMMED OPERATIONSTRONG STRONG/LOWER BACK COMBINATION STRONG/NECK & SHOULDER COMBINATIONGENTLE/LOWER BACK COMBINATION GENTLE/NECK & SHOULDER COMBINATIONShiatsu DETAILS REGARDING MANUAL OPERATIONTap A SwedishPILLOW, BACK CUSHION, SEAT AND ARMREST COVERS CLEANING AND MAINTENANCEPIPES AND PLASTIC AREAS SEAT FABRICProblem TROUBLESHOOTINGNothing can be felt when using Tap A, Tap B Cause and RemedyIt is not possible to recline the unit The power cord or power plug is abnormallyThe legrest cannot be raised or lowered Even though I press the reclining button nothing appears to happenSPECIFICATIONS EP1060 SPECIFICATIONS EP1061CONSERVE ESTAS INSTRUCCIONES INSTRUCCIONES DE SEGURIDADPRECAUCIONES DE SEGURIDAD CUIDADO DEL SILLóN DE MASAJE PRECAUCIONES PARA EL FUNCIONAMIENTOADVERTENCIA Para evitar dañar el asiento, siga estas precauciones CÓ MO MOVER EL ASIENTO CONEXIÓ N A TOMA DE TIERRAPELIGRO PRECAUCIÓ NMasaje de rodillos de 2 formas PARTES DE LA UNIDAD Y SUS FUNCIONESASIENTO MANDO DE CONTROL EP1060 MANDO DE CONTROL EP1061Tapa cerrada Tapa abiertaEMPLAZAMIENTO DE LA UNIDAD PRECAUCIONES MONTAJE DEL SILLÓ N DE MASAJEGarantice espacio suficiente para abatir el asiento Lugares que deben evitarse2. Pulse el botó n USO DEL SILLÓ N DE MASAJES - INTRODUCCIÓ N5. Apague la unidad tras finalizar el masaje ver pá gina 4. Ajuste el á ngulo del respaldo y del reposapiernas ver pá gTRAS COMPROBAR EL Á REA CIRCUNDANTE, ENCIENDA LA UNIDAD ANTES DEL USO DE LA UNIDAD1. Compruebe el á rea que rodea al silló n 2. Compruebe la unidadANTES DE SENTARSE PRECAUCIONES AJUSTE DEL ASIENTOADVERTENCIA COLOCACIÓ N DEL COJÍN2. Levantar el respaldo RECLINAR EL ASIENTO1. Reclinar el asiento 1. Pulse el botó n MODO PROGRAMADO2. Seleccione el programa deseado 3. Ajuste la posició n de los hombros5. Quitar la vibració n y percusió n de los programas 4. Seleccione una zona para el masaje localizado6. Ajustar la intensidad del masaje 7. Parada automá tica con el modo programadoMODO MANUAL EN LA PARTE SUPERIOR DEL CUERPO MODO MANUAL2. Abra la tapa del mando de control 3. Seleccione el tipo de masaje deseado5. Parada automá tica con el modo manual 4. Ajuste las configuraciones de masaje manual6. Detener el modo manual Ajustar la posició n vertical de los rodillos de masaje2. Pulse el botó n de masaje de piernas MASAJE DE PIERNAS CON EL MODO MANUAL EP10613. Ajuste de la intensidad del masaje 4. Parada automá tica del masaje de piernasDEVOLVER EL ASIENTO A LA POSICIÓ N INICIAL DESPUÉ S DE COMPLETAR EL MASAJE2. Coloque el asiento en posició n vertical 3. Introduzca el mando de control en el bolsillo2. Desenchufe el cable de alimentació n PRECAUCIONES DESCONECTAR LA UNIDAD 1. Apague la unidadFUERTE DETALLES DEL MODO PROGRAMADOSUAVE Parte superior del cuerpoFUERTE/ZONA LUMBAR FUERTE/CUELLO Y HOMBROSAmasar/Percusión B RodamientosSUAVE/ZONA LUMBAR SUAVE/CUELLO Y HOMBROSSueco/Percusión SuecoDETALLES DEL MODO MANUAL TUBOS Y Á REAS DE PLÁ STICO LIMPIEZA Y MANTENIMIENTOTEJIDO DEL ASIENTO PRECAUCIONESLOCALIZACIÓ N DE AVERÍAS ProblemaCausa y solució n Ruidos del motorEl mando de control se calienta No hay respuesta al pulsar el botó n de reclinació nLa unidad no funciona en absoluto La duració n de los programas seleccionadosDATOS TÉ CNICOS EP1060 DATOS TÉ CNICOS EP1061Page P90101060231 PrintedinJapan PanPanasonic ConsumerNo.2EN,SP(アメリカ)