Panasonic EP1060 It is not possible to recline the unit, The legrest cannot be raised or lowered

Page 27
It is not possible to recline the unit.

Problem

Cause and Remedy

It is not possible to recline the unit.

The legrest cannot be raised or lowered.

H

If the unit encounters an obstacle or if excessive

force is exerted on it during operation, in the

 

interests of safety the unit will come to a stop.

 

If all markings and buttons on the controller start to

 

flash, which is extremely unusual, turn off the power

 

switch, wait for approximately 10 seconds and then

 

turn the power switch on again.

Even though I press the reclining button nothing appears to happen.

H

When retracting the backrest, in the interests of

safety, the massage heads move to the retracted

 

position before the backrest starts to retract.

 

Please hold down the button until the backrest is fully

 

reclined.

The controller becomes warm.

H

If the unit is used continuously for an extended

 

period of time it will naturally become warm.

 

 

If the controller becomes too hot, immediately stop

 

 

using the unit and return it for inspection or repair to

 

 

the place that you bought it.

The unit will not operate at all.

Upper body (neck to lower back) massage.

Leg massage.

H

H

• The power cord has been disconnected.

(See Page 11)

The power switch on the unit has not been turned on. (See Page 11)

After pressing The legrest cannot be raised or lowered. button, the program button or the manual operation selection button has not been

pushed.

(See Pages 14–17)

The power cord has been disconnected.

The length of the programs selected in programmed operation varies.

H

• When using the massage lounger in programmed

operation, when the program is finished movement

 

automatically stops. (Although programmed

 

operation lasts for approximately 15 minutes

 

(12–17 minutes), this will vary according to the

 

shoulder position and program selected, whether or

 

not tapping is on or off, and the weight of the

 

person using the unit.)

The unit has been damaged.

H

Unplug AC cord from outlet immediately and have

massage lounger serviced.

 

 

 

The power cord or power plug is abnormally

H

Unplug AC cord from outlet immediately and have

hot.

 

massage lounger serviced.

27

Image 27
Contents Sillón de masaje EP1061/EP1060 EP1061/EP1060InstruccionesModeloNo. de uso See page INDEX / íNDICEEnglish EspañolSAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONSWARNING To avoid the risk of injury, follow these precautions SAFETY PRECAUTIONSOPERATING PRECAUTIONS WARNING To avoid damaging to the chair, follow these precautionsCARING FOR THE MASSAGER Use the casters to move the chair HOW TO MOVE THE CHAIRGROUNDING INSTRUCTIONS DANGERSEAT PART NAMES AND FUNCTIONSEP1061 EP1060ShoulderPositionIndicator CONTROLLER EP1061theunitUsed.legtovibrationtu on/offmassageandadjust AdjustmentButtonsPlaces to Avoid SETTING UP THE MASSAGE LOUNGERWHERE TO USE THE UNIT Ensure there is Adequate Space for Recliningz Plug the power plug into the power socket 1. After Carrying Out Safety Checks, Turn the Unit On See Page4. Adjust the Angle of the Backrest and Legrest See Page 5. Turn the Power Off to Finish the Massage See Pagez Plug the power plug into the power socket BEFORE USING THE UNITAFTER CHECKING THE SURROUNDING AREA, TURN ON THE POWER 3. Turn the Power OnBEFORE SITTING DOWN ADJUSTING THE SEATADJUSTING THE PILLOW Sit Down Only When the Legrest is LoweredApprox RECLINING THE SEAT1. Reclining The Seat 2. Retracting The Seat2. Select the Program You Want 3. Adjusting Shoulder PositionPROGRAMMED OPERATION 1. Press button7. Auto Stop in Programmed Operation 6. Adjusting Massage Intensity4. Selecting an Area for Concentrated Massage 5. Removing Vibration and Tapping from Programs3. Selecting the Massage Type Required MANUAL OPERATIONMANUAL OPERATION FOR THE UPPER BODY 1. Press button 2. Open the Cover of the ControllerAdjusting Massage Intensity 4. Adjusting Manual Massage SettingsAdjusting the Vertical Position of the Massage Heads Adjusting the Width between Massage Heads2. Press the Leg Massage button 3. Adjusting Massage Speed3. Adjusting Massage Intensity LEG MASSAGE IN MANUAL OPERATION EP10612. Return the Seat to the Upright Position AFTER COMPLETING THE MASSAGERETURN THE SEAT TO THE ORIGINAL POSITION 1. Check that there is Nothing Under the Backrest or the Legrest2. Unplug the Power Cord DISCONNECT THE POWER 1. Turn Off the PowerDETAILS REGARDING PROGRAMMED OPERATION STRONGGENTLE STRONG/LOWER BACK COMBINATION STRONG/NECK & SHOULDER COMBINATIONGENTLE/LOWER BACK COMBINATION GENTLE/NECK & SHOULDER COMBINATIONSwedish DETAILS REGARDING MANUAL OPERATIONShiatsu Tap ASEAT FABRIC CLEANING AND MAINTENANCEPILLOW, BACK CUSHION, SEAT AND ARMREST COVERS PIPES AND PLASTIC AREASCause and Remedy TROUBLESHOOTINGProblem Nothing can be felt when using Tap A, Tap BEven though I press the reclining button nothing appears to happen The power cord or power plug is abnormallyIt is not possible to recline the unit The legrest cannot be raised or loweredSPECIFICATIONS EP1060 SPECIFICATIONS EP1061CONSERVE ESTAS INSTRUCCIONES INSTRUCCIONES DE SEGURIDADPRECAUCIONES DE SEGURIDAD PRECAUCIONES PARA EL FUNCIONAMIENTO ADVERTENCIA Para evitar dañar el asiento, siga estas precaucionesCUIDADO DEL SILLóN DE MASAJE PRECAUCIÓ N CONEXIÓ N A TOMA DE TIERRACÓ MO MOVER EL ASIENTO PELIGROPARTES DE LA UNIDAD Y SUS FUNCIONES ASIENTOMasaje de rodillos de 2 formas Tapa abierta MANDO DE CONTROL EP1061MANDO DE CONTROL EP1060 Tapa cerradaLugares que deben evitarse MONTAJE DEL SILLÓ N DE MASAJEEMPLAZAMIENTO DE LA UNIDAD PRECAUCIONES Garantice espacio suficiente para abatir el asiento4. Ajuste el á ngulo del respaldo y del reposapiernas ver pá g USO DEL SILLÓ N DE MASAJES - INTRODUCCIÓ N2. Pulse el botó n 5. Apague la unidad tras finalizar el masaje ver pá gina2. Compruebe la unidad ANTES DEL USO DE LA UNIDADTRAS COMPROBAR EL Á REA CIRCUNDANTE, ENCIENDA LA UNIDAD 1. Compruebe el á rea que rodea al silló nCOLOCACIÓ N DEL COJÍN AJUSTE DEL ASIENTOANTES DE SENTARSE PRECAUCIONES ADVERTENCIARECLINAR EL ASIENTO 1. Reclinar el asiento2. Levantar el respaldo 3. Ajuste la posició n de los hombros MODO PROGRAMADO1. Pulse el botó n 2. Seleccione el programa deseado7. Parada automá tica con el modo programado 4. Seleccione una zona para el masaje localizado5. Quitar la vibració n y percusió n de los programas 6. Ajustar la intensidad del masaje3. Seleccione el tipo de masaje deseado MODO MANUALMODO MANUAL EN LA PARTE SUPERIOR DEL CUERPO 2. Abra la tapa del mando de controlAjustar la posició n vertical de los rodillos de masaje 4. Ajuste las configuraciones de masaje manual5. Parada automá tica con el modo manual 6. Detener el modo manual4. Parada automá tica del masaje de piernas MASAJE DE PIERNAS CON EL MODO MANUAL EP10612. Pulse el botó n de masaje de piernas 3. Ajuste de la intensidad del masaje3. Introduzca el mando de control en el bolsillo DESPUÉ S DE COMPLETAR EL MASAJEDEVOLVER EL ASIENTO A LA POSICIÓ N INICIAL 2. Coloque el asiento en posició n vertical2. Desenchufe el cable de alimentació n PRECAUCIONES DESCONECTAR LA UNIDAD 1. Apague la unidadParte superior del cuerpo DETALLES DEL MODO PROGRAMADOFUERTE SUAVERodamientos FUERTE/CUELLO Y HOMBROSFUERTE/ZONA LUMBAR Amasar/Percusión BSueco SUAVE/CUELLO Y HOMBROSSUAVE/ZONA LUMBAR Sueco/PercusiónDETALLES DEL MODO MANUAL PRECAUCIONES LIMPIEZA Y MANTENIMIENTOTUBOS Y Á REAS DE PLÁ STICO TEJIDO DEL ASIENTORuidos del motor ProblemaLOCALIZACIÓ N DE AVERÍAS Causa y solució nLa duració n de los programas seleccionados No hay respuesta al pulsar el botó n de reclinació nEl mando de control se calienta La unidad no funciona en absolutoDATOS TÉ CNICOS EP1060 DATOS TÉ CNICOS EP1061Page PanPanasonic Consumer No.2EN,SP(アメリカ)P90101060231 PrintedinJapan