Maintenance and Care Instructions

Remote Sensor Battery Installation:

1.Loosen the 4 screws securing the battery cover with a small screwdriver (included) and remove. Insert 2 alkaline AAA batteries according to the polarity direction indicated.

2.Place the home receiver (SoundSpa Premier) as close as possible to the remote sensor. This will help with synchronization between the two units.

NOTE: Once you are ready to position your remote sensor and home receiver, ensure that the distance is not outside the effective transmission range (100 feet). Some building materials and location of the home receiver or remote sensor can affect transmission quality and range. Try various locations for best results.

3.Press the C/F button inside the remote sensor to change between ºC and ºF. (The remote sensor is preset on ºF.)

4.Press the TX button inside of the remote sensor to verify the reception.

5.Replace the cover and tighten the 4 screws.

NOTE: It is recommended to test the units next to each other to ensure that both the remote sensor and home receiver are properly synchronized.

Remote Sensor Mounting Instructions

The Remote Sensor comes with a table stand or can be wall mounted.

Table Stand -

Simply fold out the attached stand from the mounting bracket.

Wall Mounting -

Set a screw in the desired hanging location and mount. A screw and wall anchor have been included for your convenience.

NOTE: Keep the remote sensor out of direct sunlight and rain. Do not mount on metal surface.

Remote Sensor Low Battery Indication

Low battery indication is available for the main unit and the remote sensor.

A battery life “ ” icon will display on both. Replace the batteries as necessary and follow the setup procedure.

•Extreme temperatures, shock or areas of unusual vibration should be avoided to prevent damage to the units.

•Clean the units using only a soft, damp cloth to wipe. Do not use solvents, abrasives, detergents or other strong cleaning agents. After cleaning, wipe surfaces with a dry cloth.

•Do not submerge units in water or other liquids.

•Do not subject the units to extremely severe temperatures - DO NOT PLACE

UNITS INTO OVENS, FREEZERS or MICROWAVE UNITS.

NOTE: Opening the housing (other than the battery compartment) of the Remote Sensor or the SoundSpa Unit will invalidate your warranty. Do not attempt to repair this unit - There are no consumer serviceable parts.

TROUBLE SHOOTING

Indoor and Outdoor temperatures do not match when placed next to each other -

The sensor is manufactured to be +/- 2 degree in accuracy under normal conditions. So it is possible to have up to four degrees difference shown on the separate temperature sensors (one could be “+2 degree” and the other “-2 degree”. Additionally, the calibration curve is different between the two units because of the greater temperature range of the outdoor sensor. Errors are usually noted on the extreme ends of the temperature ranges.

SoundSpa unit is not accepting remote transmissions -

The units may not be properly synchronized or the batteries may need to be replaced. See “USING OUTDOOR TEMPERATURE” section for detailed instructions. With the two units next to each other, attempt synchronization. Remember to always place the remote sensor within the effective transmission range and away from large metal surfaces.