Assembly and Instructions for Use, Setting Time

Assembly and Instructions for Use

1.Unpack the product and check to make sure everything is included. (Fig. 1)

2.This unit is powered by a DC adaptor, which is included.

3.The battery power is designed only to provide MEMORY BACK-UP for the clock and alarm settings. One 9 Volt battery (not included) should be inserted into the battery compartment if memory back-up is desired (in the event of power outages or if the unit is unplugged). The time will be illuminated on the clock display, however, the backlight will not be illuminated. As soon as the power supply returns, the display will indicate the correct time.

Note: Battery must be installed in order for clock memory back-up to operate. In the event of a power failure or disconnection, if the battery is not installed, the clock and alarm will need to be re-set when power is restored.

4.To install battery, remove compartment cover. Insert one 9 Volt battery into the compartment on the bottom of the unit. Replace cover and snap into place.

5.Attach the DC adaptor jack to the base of the unit (Fig. 3) and insert the cord into a 120V household outlet.

Setting Time

Using the Atomic Time

The Sound Spa Platinum will start synchronizing the clock to the Pacific Time Zone as soon as the unit is plugged in.

Selecting a time zone

1.Press the ATOMIC ON/OFF button (Fig. 3) to turn off the atomic time function. To indicate you are at the off position, the antenna icon will be removed from the display.

2.Toggle through the TIME ZONE button (Fig. 3) until you reach your desired time zone. (P - Pacific Standard Time, M - Mountain Standard Time, C - Central Standard Time, E - Eastern Standard Time)

3.Once you have selected your time zone, press the ATOMIC ON/OFF button again to turn on the atomic time function. To indicate you are at the on position, the antenna bands , over the satellite icon ,will reappear flashing. (When it appears flashing the unit is searching for the atomic time signal.)

4.If the antenna bands disappears afterwards, the atomic time signal is not available at that moment. Try setting the unit in other locations. Remember to place the unit away from sources of interference such as mobile phones, appliances, TV etc.

5.The antenna bands will appear on screen if the atomic time reception is successful. The radio-controlled clock will have a daily synchroniza- tion at 1:00 am everyday. If previous attempts of reception were unsuc- cessful, the home receiver will attempt synchronization each hour until successful. Each reception cycle ranges from 2 – 10 minutes.

Note: You can adjust the backlight intensity on the LCD screen by moving the BACKLIGHT High/Low switch (Fig. 3) on the back of the unit.