Servis-Rhino SR10M, SR15M manual Assembly, Blade Carrier And Blades

ASSEMBLY

ASSEMBLY

Set up mower as received from factory with these instructions. Refer to Parts Listing Section for further information when necessary.

Select a suitable working area. Open parts box and lay out parts to make location easy. Refer to parts listing and exploded view drawings in the Parts Listing Section and the packing list.

Cut all wire ties, including those on blades if present.

This mower is shipped partially assembled. Assembly will be easier if components are aligned and loosely assembled before tightening hardware. Refer to Torque Chart when tightening hardware.

Position Center Section on a flat surface. Elevate approximately 10 inches from ground to permit the installation of Wing Sections.

BLADE CARRIER AND BLADES

The Frame sections are shipped from the factory without the Blades attached to the Blade Carrier. Optional Straight or Fan Blades are available.

WARNING Do not install Blades or do any work under the Cutter sections unless the section(s) are safely and securely blocked or latched in place.

The Blade Bolts must be tightened to 250 ft. lbs. torque before operating. NOTE: Blade Bolts have left-hand threads.

To insure proper installation, check to see that Blade cutting surfaces are correct for counterclockwise rotation on the Center Section and on the Right Wing Blade Carrier. FIGURE 1. (Clockwise on Left Wing)

Blade Carrier Left Wing Shown NOTE: Cutting Edge for Clockwise Rotation

FIGURE 1

FIGURE 1

SR10M/SR15M 10-01 Assembly Section 3-2

© 2004 Alamo Group Inc.