MAINTENANCE
MAIN CV DRIVELINE SAFETY SHIELD
1.To remove the outer CV cone, remove the locking screws from shield cone. Remove cone over yoke. FIGURE 7. Remove bearing ring and remove the locking screws from inner shield cone. Figure 8. Turn inner cone to assembly position and remove half shield. Remove bearing ring. FIGURE 9.
FIGURE 7 | FIGURE 8 |
|
FIGURE 9
1.To assemble outer CV driveline, grease yoke groove and inner profile tube. Attach bearing ring on groove with recesses facing profile tube. FIGURE 10. Slide on half shield with cone. Turn cone until it engages correctly. FIGURE 11. Tighten locking screws. Grease bearing groove in double yoke. FIGURE 12. Insert bearing ring. Slide guard cone for double yoke over cam from the connecting end. Make sure holes for screws are visible. FIGURE 13. Tighten locking screws. FIGURE 14.
FIGURE 10 | FIGURE 11 |
FIGURE 12 | FIGURE 13 |
| FIGURE 14 |
SR10M/SR15M | Maintenance Section |
© 2004 Alamo Group Inc.
