Servis-Rhino SR10M, SR15M manual Lubrication Information, Wheel HUB Assembly

MAINTENANCE

MAINTENANCE

Before operating your Rotary Cutter, make sure it is properly lubricated and thoroughly inspected. Only a minimum of time and effort is required to regularly lubricate and maintain this machine to provide long life and trouble free operation.

WARNING Always disengage the PTO before raising the Rotary Cutter for transporting or making adjustments.

LUBRICATION INFORMATION

Do not let excess grease collect on or around parts, particularly when operating in sandy areas. The accompanying illustration shows lubrication points. The chart gives the frequency of lubrication in hours, based on normal operating conditions. Severe or unusual conditions may require more frequent lubrication. FIG. 1.

Use an SAE multi-purpose, lithium-type grease for all locations shown except location #2. On center and wing gearbox use recommended lubricant on following page. Be sure to clean the fitting thoroughly before using grease gun. Daily lubrication of the wing driveline slip joint is necessary. Failure to maintain proper lubrication will result in damage to U-joints, gearbox, and/or driveshaft. FIGURE 1.

						Lubrication Fitting Location
					ITEM	Description	Frequency
					1	U-Joints	8 Hours
			2		2	Gearbox	Check daily
					3	Divider Gearbox	Check daily
					4	Axle Adjustment Rod	8 Hours
	3	1			5	Tongue Pivot	8 Hours
5			1	2	6	Wheel Hubs	Weekly
1					7	Telescoping Members	8 Hours
						4
						6

7

WHEEL HUB ASSEMBLY

Grease Weekly

The Wheel Hub Assemblies need to be lubricated on a weekly basis.

SR10M/SR15M 10-01 Maintenance Section 5-2

© 2004 Alamo Group Inc.